Cisco 200-301 Free Practice Questions

NEW QUESTION 1
Refer to the exhibit.

Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

• A. passive
• B. mode on
• C. auto
• D. active

Answer: A

NEW QUESTION 2
Which two actions influence the EIGRP route selection process? (Choose two)

• A. The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.
• B. The router calculates the best backup path to the destination route and assigns it as the feasible successor.
• C. The router calculates the feasible distance of all paths to the destination route
• D. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link
• E. The router must use the advertised distance as the metric for any given route

Answer: AD

NEW QUESTION 3
Refer to Exhibit.

Which action do the switches take on the trunk link?

• A. The trunk does not form and the ports go into an err-disabled status.
• B. The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.
• C. The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.
• D. The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.

Answer: C

NEW QUESTION 4
An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 5
An engineer must configure a WLAN using the strongest encryption type for WPA2- PSK. Which cipher fulfills the configuration requirement?

• A. WEP
• B. RC4
• C. AES
• D. TKIP

Answer: D

NEW QUESTION 6
Drag and drop the functions from the left onto the correct network components on the right

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 7
Refer to Exhibit.

How does SW2 interact with other switches in this VTP domain?

• A. It processes VTP updates from any VTP clients on the network on its access ports.
• B. It receives updates from all VTP servers and forwards all locally configured VLANs out all trunk ports
• C. It forwards only the VTP advertisements that it receives on its trunk ports.
• D. It transmits and processes VTP updates from any VTP Clients on the network on its trunk ports

Answer: C

NEW QUESTION 8
Refer to the exhibit.

Which route does R1 select for traffic that is destined to 192 168.16.2?

• A. A.-192.168.16.0/21B.192.168.16.0/24C.192.168 26.0/26D.192.168.16.0/27

Answer: B

NEW QUESTION 9
What is the primary effect of the spanning-tree portfast command?

• A. it enables BPDU messages
• B. It minimizes spanning-tree convergence time
• C. It immediately puts the port into the forwarding state when the switch is reloaded
• D. It immediately enables the port in the listening state

Answer: A

NEW QUESTION 10
Which type of wireless encryption is used for WPA2 in preshared key mode?

• A. TKIP with RC4
• B. RC4
• C. AES-128
• D. AES-256

Answer: D

NEW QUESTION 11
Refer to the exhibit.

Drag and drop the networking parameters from the left onto the correct values on the right. Check the answer below.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 12
Refer to the exhibit.

If OSPF is running on this network, how does Router 2 handle traffic from Site B to 10.10.13/25 at Site A?

• A. It sends packets out of interface Fa0/2 only.
• B. It sends packets out of interface Fa0/1 only.
• C. It cannot send packets to 10.10.13 128/25
• D. It load-balances traffic out of Fa0/1 and Fa0/2

Answer: D

NEW QUESTION 13
Which IPv6 address block sends packets to a group address rather than a single address?

• A. 2000::/3
• B. FC00::/7
• C. FE80::/10
• D. FF00::/8

Answer: C

NEW QUESTION 14
What are two characteristics of a controller-based network? (Choose two)

• A. The administrator can make configuration updates from the CLI
• B. It uses northbound and southbound APIs to communicate between architectural layers
• C. It moves the control plane to a central point.
• D. It decentralizes the control plane, which allows each device to make its own forwarding decisions
• E. It uses Telnet to report system issues.

Answer: AC

NEW QUESTION 15
Drag drop the descriptions from the left onto the correct configuration-management technologies on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 16
Which output displays a JSON data representation?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 17
Refer to the exhibit.

What is the effect of this configuration?

• A. The switch port interface trust state becomes untrusted
• B. The switch port remains administratively down until the interface is connected to another switch
• C. Dynamic ARP inspection is disabled because the ARP ACL is missing
• D. The switch port remains down until it is configured to trust or untrust incoming packets

Answer: A

NEW QUESTION 18
What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?

• A. The Layer 2 switch drops the received frame
• B. The Layer 2 switch floods packets to all ports except the receiving port in the given VLAN.
• C. The Layer 2 switch sends a copy of a packet to CPU for destination MAC address learning.
• D. The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table

Answer: B

NEW QUESTION 19
Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 20
Drag and drop the network protocols from the left onto the correct transport services on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 21
Which statement identifies the functionality of virtual machines?

• A. Virtualized servers run most efficiently when they are physically connected to a switch that is separate from the hypervisor
• B. The hypervisor can virtualize physical components including CP
• C. memory, and storage
• D. Each hypervisor can support a single virtual machine and a single software switch
• E. The hypervisor communicates on Layer 3 without the need for additional resources

Answer: D

NEW QUESTION 22
......