Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. A company is implementing an Identity Management solution with these characteristics:
1) existing AAA Server
2) Cisco Catalyst switches
3) minimal added investments
Which Cisco Trust and Identity Management solution would you recommend?
A. NAC Appliance
B. Cisco IBNS
C. CSM
D. Cisco Security MARS
Answer: B
Q2. Which two methods are used to reduce the mesh links required between iBGP peers in the same AS? (Choose two.)
A. community
B. router reflectors
C. local preference
D. confederations
E. atomic aggregate
F. MED
Answer: B,D
Q3. DRAG DROP
Answer:
Q4. DRAG DROP
Answer:
Q5. Which three items pertain to EIGRP? (Choose three.)
A. Can use multiple unequal paths.
B. Routes are redistributed as type 2 by default.
C. ASN and K values must match to form neighbors.
D. Uses multicast address 224.0.0.9 for updates.
E. Exchanges full routing table every 30 seconds.
F. Summary routes have AD of 90.
G. External routes have AD of 170.
Answer: A,C,G
Q6. ACME corporation is implementing dynamic routing on the LAN at its corporate headquarters. The interior gateway protocol that they select must support these requirements: multivendor environment, efficient subnetting, high scalability, and fast convergence..Which interior gateway protocol should they implement?
A. EIGRP
B. OSPF
C. RIPng
D. BGP
Answer: B
Q7. Refer to the exhibit.
Which three modules would typically utilize public IPv4 addressing? (Choose three.)
A. Access
B. Distribution
C. Core
D. Data Center
E. E-Commerce
F. Internet Connectivity
G. Remote Access/VPN
H. WAN/MAN
I. Branch
J. Branch Data Center
Answer: E,F,G
Q8. DRAG DROP
Answer:
Q9. Which two routing protocols operate over NBMA point-to-multipoint networks without the use of point-to-point sub interfaces? (Choose two.)
A. RIPv1
B. RIPv2
C. IS-IS
D. EIGRP
E. OSPF
Answer: D,E
Q10. Which is a factor in enterprise campus design decisions?
A. network application characteristics
B. routing protocol characteristics
C. switching latency characteristics
D. packet filtering characteristics
Answer: A
Q11. Which is the equation used to derive a 64 Kbps bit rate?
A. 2 x 8 kHz x 4-bit code words
B. 8 kHz x 8-bit code words
C. 2 x 4-bit code words x 8 kHz
D. 2 x 4 kHz x 8-bit code words
Answer: D
Q12. Which IPv6 feature enables routing to distribute connection requests to the nearest content server?
A. Link-local
B. Site-local
C. Anycast
D. Multicast
E. Global aggregatable
Answer: C
Explanation: Any cast is a network addressing and routing methodology in which data grams from a single sender are routed to the topologically nearest node in a group of potential receivers all identified by the same destination address. Link: http://en.wikipedia.org/wiki/Anycast
Q13. With respect to IPv6 addressing, from a design perspective, which of these statements is it important to keep in mind?
A. IPv6 addressing provides convenience of anycast addressing without any configuration requirements.
B. IPv6 does not use multicast addressing.
C. An IPv6 router will not forward packets from one link to other links if the packet has either a link-local source or a link-local destination address.
D. Dynamic address assignment requires DHCPv6.
Answer: C
Q14. What three primary sources of information are needed to perform a network audit? (Choose three.)
A. existing documentation
B. new documentation
C. existing network management software
D. new network management tools
E. management personnel
F. technical personnel
Answer: A,C,D
Q15. Which two design approaches provide management of enterprise network devices? (Choose two.)
A. in-band
B. out-of-line
C. out-of-band
D. in-line
Answer: A,C
Q16. A circuit order has been placed for Gigabit Ethernet and is 80KM from the carrier equipment. What type of SFP will be required?
A. TX
B. SX
C. ZX
D. LX
Answer: C