Q1. Where in the Cisco Enterprise Architecture model does network management reside?
A. Enterprise data center module
B. Enterprise campus module
C. Enterprise edge module
D. Service Provider edge module
E. Service Provider data center module
Answer: B
Explanation:
The network management servers reside in the campus infrastructure but have tie-ins to all the components in the enterprise network for monitoring and management.
Q2. A remote office has a T1 WAN link to headquarters and a T1 Internet connection. The client requests WAN redundancy to headquarters with similar bandwidth. What two connection types satisfy this requirement? (Choose two.)
A. Secondary T1 WAN circuit
B. ISDN BRI
C. IPSec Tunnel over the Internet
D. DWDM l
E. POTS Line T1 WAN
Answer: A,C
Q3. What significant advantage does EIGRP have over OSPF?
A. easy summarization
B. shorter convergence times
C. single area operation
D. low processor utilization
Answer: B
Q4. A network engineer must implement a design where LAN clients are to connect.to various access layer devices, while remaining on the same VLAN . What type of design would support this requirement?
A. routed
B. switched
C. tunneled
D. virtual
Answer: B
Q5. Which IPv6 feature enables routing to distribute connection requests to the nearest content server?
A. Link-local
B. Site-local
C. Anycast
D. Multicast
E. Global aggregatable
Answer: C
Explanation: Any cast is a network addressing and routing methodology in which data grams from a single sender are routed to the topologically nearest node in a group of potential receivers all identified by the same destination address. Link: http://en.wikipedia.org/wiki/Anycast
Q6. Which subnet address and mask would you use for all Class D multicast addresses to be
matched within an access list?
A. 224.0.0.0/20
B. 224.0.0.0/4
C. 239.0.0.0/24
D. 239.0.0.0/8
E. 225.0.0.0/8
Answer: B
Q7. When you are designing a large IPv6 multivendor network, which IGP does Cisco recommend that you use?
A. OSPFv3
B. EIGRP for IPv6
C. BGP
D. RIPng
Answer: A
Q8. What wireless authentication option requires a Public Key Infrastructure?
A. EAP-TLS
B. PEAP
C. LEAP
D. EAP-FAST
Answer: A
Q9. To what Layer 2 technology does VRF closely compare?
A. VSS
B. VPC
C. VLAN
D. VTP
Answer: C
Q10. Refer to the exhibit.
Which layer is the distribution layer?
A. Layer A
B. Layer B
C. Layer C
D. Layers A and B form a consolidated core and distribution layer
Answer: B
Q11. Which three technologies are recommended to be used for WAN connectivity in today's Enterprise Edge designs? (Choose three.)
A. DWDM
B. Metro Ethernet
C. Frame Relay
D. MPLS VPN
E. ISDN
F. DSL
G. Wireless
Answer: A,B,D
Explanation:
There is some discussion about whether ISDN not DWDM should be the answer but it does say TODAYS network
Q12. Which three Cisco technologies can you use to detect and mitigate threats? (Choose three.)
A. NetFlow
B. FWSM
C. ISE
D. VRRP
E. sFLOW
Answer: A,B,C
Q13. A network engineer is designing an enterprise managed VPN solution for a large number of remote offices that do not have on-site IT support and communicate only with the home office. What type of VPN solution should be implemented?
A. VPLS
B. GRE
C. IPsec
D. EVPN
E. DMVPN
F. SSL client
Answer: D
Q14. ACME corporation is implementing dynamic routing on the LAN at its corporate headquarters. The interior gateway protocol that they select must support these requirements: multivendor environment, efficient subnetting, high scalability, and fast convergence..Which interior gateway protocol should they implement?
A. EIGRP
B. OSPF
C. RIPng
D. BGP
Answer: B
Q15. What three primary sources of information are needed to perform a network audit? (Choose three.)
A. existing documentation
B. new documentation
C. existing network management software
D. new network management tools
E. management personnel
F. technical personnel
Answer: A,C,D
Q16. Which two devices would you place in your DMZ to ensure enterprise edge security? (Choose two.)
A. IPS
B. NAC
C. ASA
D. ACS
E. WCS
Answer: A,C