Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. Refer to the exhibit.
Which tab is used to set up web authentication for guest users?
A. Security > Layer 3
B. Security > Layer 2
C. Security > AAA Servers
D. Advanced
E. General
Answer: A
Q2. What must be done for Cisco WLC and Cisco WCS to communicate?
A. The IP address and subnet mask of the Cisco WLC must be configured in the Cisco WCS.
B. The IP address and subnet mask of the Cisco WCS must be configured in the Cisco WLC.
C. The identity certificate of the Cisco WLC must be added to the Cisco WCS.
D. The Cisco WLC and Cisco WCS must exchange identity certificates.
Answer: A
Q3. How are application-specific devices differentiated from laptop computers in the way they support Cisco Compatible Extensions?
A. ASDs are required to support only Cisco Compatible Extensions v1 and v2 features. Laptops must support all Cisco Compatible Extensions features.
B. ASDs are required to support only Cisco Compatible Extensions v5 management features, while laptops are required to support optional features.
C. Several features that are required for laptops are not required for ASDs.
D. There is no differentiation. ASDs and laptops must both support the same Cisco Compatible Extensions features.
Answer: C
Q4. You run minimum PEAP-GTC authentication in your wireless environment. Which version of Cisco Compatible Extensions supports PEAP-GTC?
A. Cisco Compatible Extensions v1
B. Cisco Compatible Extensions v2
C. Cisco Compatible Extensions v3
D. Cisco Compatible Extensions v4
E. Cisco Compatible Extensions v5
Answer: B
Q5. Which three WLC debug commands are appropriate to troubleshoot a wireless client that is associated to an AP? (Choose three.)
A. debug capwap
B. debug mac addr
C. debug dot11
D. debug dhcp
E. debug ap
F. debug dtls
Answer: B,C,D
Q6. The network administrator receives complaints of slow wireless network performance and performs a sniffer trace of the wireless network in preparation for migration to 802.11n. The sample capture shows frames that contains AP beacons with NonERP_Present bit set to 1 and frames with RTS/CTS.
Which two conclusions can be interpreted from these frames? (Choose two.)
A. The network is performing slowly because 802.11n clients are already mixed with 802.11g clients.
B. The network is performing slowly because 802.11b clients still exist in the network.
C. The network is performing slowly because a wireless client is incorrectly configured, which results in RF interference.
D. Possible 802.11b wireless clients are located only in the AP cell radius where the sniffer capture was performed.
E. Possible 802.11b wireless clients could be located anywhere in the wireless network.
Answer: B,E
Q7. The existing Cisco Unified Wireless Controller is running version 7.0 code for both the controllers and the Cisco WCS. A controller has been configured with an appropriate rogue rule condition to report discovered APs to the Cisco WCS.
Which default alarm level is used to display all rogue APs in the Alarm Summary?
A. Critical
B. Flash
C. Urgent
D. Major
E. Minor
Answer: E
Q8. A network engineer is connected via wireless to a Cisco AireOS WLC and wants to download the configuration but is unable to do so. Which change will correct the issue?
A. enable management via wireless
B. connect via wired network
C. enable Telnet
D. enable WebAuth SecureWeb
E. connect on 5-GHz SSID
Answer: B
Q9. During an upgrade, the wireless infrastructure has seen a few access points join and then drop off the network. After further investigation, it appears the access points may have an IOS code version that is causing issues. Where in the controller is this information found?
A. GUI > Wireless > Access Point > General
B. CLI > show ap image all
C. GUI > Monitor > Software Version
D. CLI > show sysinfo
Answer: A
Q10. A network engineer is troubleshooting a LAP that is unable to join the controller and receives the message below:
LWAPP_CLIENT_ERROR_DEBUG. No more AP manager IP addresses remain What does the log indicate?
A. Two or more LAPs have the same IP address.
B. An AP manager has the same IP address as another AP manager.
C. A LAP has the same IP address as the AP manager.
D. Two or more controllers have the same IP address.
Answer: C
Q11. What is the equivalent of 26 dBm in milliwatts?
A. 4 mW
B. 40 mW
C. 100 mW
D. 400 mW
E. 1000 mW
Answer: D
Q12. A company wants to implement wireless in all 20 remote office locations and wants centralized management of these remote sites. What application would meet the requirements?
A. Control And Provisioning of Wireless Access Points
B. Cisco point- to multi-point wireless bridging
C. Cisco autonomous access points in FlexConnect mode
D. Split MAC architecture utilizing LWAPP and WLC
Answer: D
Q13. Which two destinations can Cisco WCS administrators specify for a scheduled report? (Choose two.)
A. a file on the Cisco WCS
B. a specified email address
C. a specified World Wide Web server
D. a TFTP server
Answer: A,B
Q14. If an antenna has a dBd of 8.6, what is the dBi value?
A. 6.2
B. 6.46
C. 8.6
D. 10.74
E. 12.88
Answer: D
Q15. Which command path correctly describes how to access and troubleshoot clients with Cisco WCS version 7.0?
A. Tools > Clients > select displayed client's MAC address
B. Tools > Clients > enter client's MAC address
C. Monitor > Clients > click displayed client's MAC address
D. Monitor > Clients > enter client's MAC address
Answer: C