Q1. Refer to the exhibit. A customer is determining whether a Windows 7 laptop is operating on the correct IEEE 802.11 standard. Which standard is being used by the laptop in the exhibit?
A. 802.11b
B. 802.11g
C. 802.11n
D. 802.11p
Answer: C
Q2. Which three options relate to event-driven RRM? (Choose three.)
A. any 802.11n AP models
B. specific AP models
C. minimum of AP and WLC
D. minimum of AP, WLC, and WCS
E. minimum of AP, WLC, WCS, and MSE
F. configurable in WLC at 802.11b/g/n > RRM > TPC
G. configurable in WLC at 802.11b/g/n > RRM > DCA
Answer: B,C,G
Q3. What are three characteristics of WCS? (Choose three.)
A. based on a single server licensing system
B. used for wireless planning
C. used for real-time tracking of multiple clients
D. used for wireless management
E. used for RF fingerprinting
F. based on a per server licensing system
Answer: A,B,D
Q4. Which operating mode is valid for controllers in a converged access architecture?
A. switch peer groups
B. mobility controller
C. auto-anchor
D. foreign anchor
Answer: B
Q5. In what WCS menu would an engineer locate the WCS software version?
A. Administration > Settings
B. Help > About Cisco WCS
C. Help > Online Help
D. Administration > License Center
Answer: B
Q6. What is the approximate time difference for a client to perform an intracontroller roam compared to an intercontroller roam?
A. 1 ms
B. 10 ms
C. 20 ms
D. 30 ms
Answer: B
Q7. An engineer wants to setup WPA2 Enterprise using EAP-TLS and a remote RADIUS server. What device(s) would the engineer specify the EAP type on?
A. the supplicant and authentication server
B. the supplicant and authenticator
C. the authenticator and authentication server
D. the supplicant only
E. the authentication server only
Answer: A
Q8. A wireless engineer is designing the wireless networking for a company with offices in two different locations. Which two regulatory bodies should they check to find the maximum EIRP allowed? (Choose two.)
A. IEEE
B. FCC
C. ITU-R
D. ETSI
E. Wi-Fi Alliance
Answer: B,D
Q9. During an upgrade, the wireless infrastructure has seen a few access points join and then drop off the network. After further investigation, it appears the access points may have an IOS code version that is causing issues. Where in the controller is this information found?
A. GUI > Wireless > Access Point > General
B. CLI > show ap image all
C. GUI > Monitor > Software Version
D. CLI > show sysinfo
Answer: A
Q10. RAG DROP
Answer: