Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. Which two algorithms are available in RRM? (Choose two.)
A. coverage-hole detection
B. dynamic channel assignment
C. RSSI normalizer
D. transmitting channel expander
E. rogue detection
Answer: A,B
Q2. What are three characteristics of the 802.11g standard? (Choose three.)
A. speed of as much as 11 Mb/s
B. speed of as much as 54 Mb/s
C. backward-compatibility with 802.11a
D. backward-compatibility with 802.11b
E. OFDM as an additional modulation technique
F. OFDM and CCK as additional modulation techniques
Answer: B,D,E
Q3. During a wireless site survey, the signal strength drops significantly when outside of the room containing the access point. The building is made of wood and drywall. This is an example of which wireless anomaly?
A. absorption
B. refraction
C. fading
D. multipath
E. reflection
Answer: A
Q4. An engineer would like to setup secure authentication for a wireless network that will utilize single sign-on. Which two authentication methods can be used to accomplish this? (Choose two.)
A. LDAP
B. RADIUS
C. Local authentication
D. WEP
E. PSK
Answer: A,B
Q5. Refer to the exhibit.
At which point in the network topology must the trunk be configured to support multiple SSIDs for voice and data separation?
A. A
B. B
C. C
D. D
Answer: D
Q6. Which official port should be used when configuring external RADIUS authentication on a Cisco WLC version 7.0?
A. 49
B. 1645
C. 1646
D. 1812
E. 1813
Answer: D
Q7. What two methods of authentication are available for Local EAP?
A. LDAP and RADIUS
B. Local and RADIUS
C. Local Only
D. LDAP and Local
Answer: D
Q8. What two AP configurations will show RF prediction on maps in WCS? (Choose two.)
A. Lightweight APs with internal antennas
B. Lightweight APs with external Cisco antennas
C. Lightweight APs with external 3rd Party antennas
D. Autonomous APs with internal antennas
E. Autonomous APs with external Cisco antennas
F. Autonomous APs with external 3rd Party antennas
Answer: A,B
Q9. A controller is connected to a Cisco Catalyst switch. The switch port configuration looks like this:
interface GigabitEthernet 1/0/10
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,20,30,50
switchport trunk native vlan 20
switchport mode trunk
Which controller CLI command assigns its management interface to the native VLAN interface of the Cisco Catalyst switch?
A. config interface vlan management 0
B. config interface vlan management 1
C. config interface vlan management 20
D. config interface vlan management 30
E. config interface vlan management 50
Answer: A
Q10. Which wireless client attempts to authenticate by using 802.1X?
A. supplicant
B. authenticator
C. EAP
D. RADIUS
Answer: A
Q11. What tool can be used to increase accuracy of WCS heat maps?
A. Map Editor
B. Planning Tool
C. CleanAir
D. Cisco Spectrum Expert
Answer: A
Q12. To implement a more secure means of communication for voice and data, what technology successfully resists interference by utilizing a wider bandwidth than needed for the transmitting signal?
A. Spread Spectrum
B. Microwave
C. Extended U-NII2
D. ISM Bands
Answer: A
Q13. Which three AP modes of operation allow for the wIPS sub mode? (Choose three.)
A. local mode
B. bridge mode
C. monitor mode
D. H-REAP mode
E. rogue detector mode
F. SE-Connect mode
G. sniffer mode
Answer: A,C,D
Q14. Which key combination provides a detailed wireless connection status for an Apple MacBook running 10.6?
A. Command + Click the SSID of the network
B. Alt + Click the SSID of the network
C. Command + the Airport icon
D. Option + the Airport icon
E. Ctrl + the Airport Icon
F. Option + Click the SSID of the network
Answer: D
Q15. What is the equivalent of 26 dBm in milliwatts?
A. 4 mW
B. 40 mW
C. 100 mW
D. 400 mW
E. 1000 mW
Answer: D