Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. When a guest client is authenticated, which type of connection is created between the controller-based AP and the client?
A. as SSL connection
B. a TLS encrypted tunnel
C. an unsecured connection
D. a 802.1x/EAP tunnel
E. an IPsec tunnel
Answer: C
Q2. A wireless bridge is being installed near an airport. An organization informs the city council about complying with max power levels that could be used and settings on any 5GHz channels used that might interfere with the airport radar. What organization is this?
A. Institute of Electrical and Electronics Engineers
B. Internet Engineering Task Force
C. Federal Communications Commission
D. Wireless Fidelity Alliance
Answer: C
Q3. Which Cisco AnyConnect module provides wireless connectivity?
A. telemetry
B. web security
C. VPN
D. NAM
E. DART
F. posture
G. CSSC
Answer: D
Q4. Which information on the Monitoring page of a Cisco WLC verifies that the wireless network is operational?
A. In the Access Point Summary section, the All APs number in the Up column is the same as in the Total column.
B. In the Client Summary section, the Current Clients number is positive.
C. In the Controller Summary section, the 802.11b/g Network State is shown as Enabled.
D. In the Controller Summary section, the CPU Usage number is positive.
Answer: A
Q5. What protocol is used to determine the best pathway back to a root access point?
A. CCKM
B. WNMP
C. AWPP
D. LWAP
Answer: C
Q6. What is a risk when initiating the containment of a rogue AP?
A. disassociating clients of valid access points that are operated by a neighboring organization
B. disrupting transmission of neighboring AP clients
C. breaking the radio of the containing AP
D. breaking the rogue client radio or its firmware
Answer: A
Q7. Refer to the exhibit. The wireless engineer has deployed the Cisco 5508 Wireless Controller. The controller is responding on the service port; however, it will not respond on the management interface. Which configuration revision will fix the management interface?
A. On the switch interface, configure switch(config-if)#switchport trunk allowed vlan add 10.
B. On the WLC management interface, disable LAG on the management network.
C. On the switch interface, configure switch(config-if)#switchport trunk allowed vlan 10.
D. On the WLC management interface, change the VLAN ID to 20.
E. On the switch interface, configure no spanning-tree portfast trunk.
F. On WLC Controller > General, disable LAG and reboot.
Answer: A
Q8. Which single tool helps to troubleshoot client-related issues in a WLAN?
A. The show and debug commands on the controller.
B. The show commands on the AP.
C. Client templates on the Cisco WCS.
D. Client troubleshooting on the Cisco WCS.
Answer: D
Q9. RAG DROP
Answer:
Q10. Refer to the exhibit.
Which two options does this icon represent about the status of the respective AP on a Cisco WCS version 7.0 map? (Choose two.)
A. The 802.11a/n radio is administratively disabled.
B. The 802.11a/n radio has a minor fault.
C. The 802.11a/n radio has a major fault.
D. The 802.11b/g/n radio is administratively disabled.
E. The 802.11b/g/n radio has a minor fault.
F. The 802.11b/g/n radio has a major fault.
Answer: C,D
Q11. A lightweight AP has been deployed in local mode in a network that consists of 10 wireless LAN controllers in a single mobility group. The AP has been configured to use primary, secondary, and tertiary Cisco WLCs. Due to a major power failure, all those Cisco WLCs are unavailable.
Which step does the AP take next?
A. The AP reboots and repeatedly attempts to join the configured primary, secondary, and tertiary Cisco WLCs in that order. The process continues until one of the configured Cisco WLCs is available.
B. The AP attempts to join a Cisco WLC configured as a master controller.
C. The AP attempts to join the Cisco WLC that has the greatest capacity available.
D. The AP state transitions to AP Fallback Mode and continues to provide limited WLAN services (that is, no new client authentications) until a Cisco WLC is available.
Answer: B
Q12. An engineer is adding a controller to a WCS. What three categories of parameters are needed? (Choose three.)
A. IP parameters
B. SNMP Parameters
C. Mobility Parameters
D. Telnet/SSH Parameters
E. TFTP Parameters
F. RADIUS Parameters
Answer: A,B,D
Q13. What are two wireless configuration utilities for Apple Mac computers? (Choose two.)
A. AirPort
B. AirPort Extreme
C. AirManager
D. AirManager Supreme
E. AirAssistant Ultimate
Answer: A,B
Q14. Which protocol helps the administrator to determine whether a detected rogue AP is in the network of the organization?
A. RLDP
B. RCP
C. RDP
D. RAPP
Answer: A
Q15. Which two Cisco Unified Wireless Network capabilities use information that is provided by Radio Resource Management neighbor messages in version 7.0 MR1? (Choose two.)
A. aggressive load balancing
B. dynamic channel assignment
C. hybrid remote edge access point
D. inter-controller mobility (that is, mobility groups)
E. rogue AP classification
Answer: B,E