Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. The AP is unable to join the WLC. What switch configuration will correct this problem?
A. interface vlanl ip helper-address 10.10.10.10
B. interface vlan20 ip helper-address 10.10.10.10
C. ipdhcp pool vlanl option 43 ascii '10.10.10.10'
D. ip dhcp pool vlan20 option 43 ascii '10.10.10.10'
E. ipdhcp pool vlanl option 43 hex f1040a0a0a0a
F. ip dhcp pool vlan20 option 43 hex f1040a0a0a0a
Answer: F
Q2. Refer to the exhibit.
Cisco WCS version 7.0 has a configuration mismatch with what is actually running in the controller. Which menu leads to the Audit Status Report?
A. Security
B. Monitor
C. Configure
D. Services
E. Administration
F. Tools
Answer: C
Q3. What must be done for Cisco WLC and Cisco WCS to communicate?
A. The IP address and subnet mask of the Cisco WLC must be configured in the Cisco WCS.
B. The IP address and subnet mask of the Cisco WCS must be configured in the Cisco WLC.
C. The identity certificate of the Cisco WLC must be added to the Cisco WCS.
D. The Cisco WLC and Cisco WCS must exchange identity certificates.
Answer: A
Q4. Refer to the exhibit.
A wireless network that consists of Cisco Aironet 1260 APs and Cisco 2100 Series WLC has been correctly configured with Cisco WCS version 7, which is also used for management. The CleanAir Zone of Impact is not visible for the respective Cisco WCS maps.
Which two issues are causing the problem? (Choose two.)
A. software version
B. AP
C. Cisco WLC
D. Cisco MSE
E. Cisco WCS
F. Cisco WCS is not enabled.
Answer: B,D
Q5. Which statement about the impact of configuring a single SSID to support TKIP and AES encryption simultaneously is true?
A. The overhead associated with supporting both encryption methods significantly degrades client throughput.
B. Some wireless client drivers might not handle complex SSID settings and may be unable to associate to the WLAN.
C. This configuration is unsupported and the Cisco Wireless Control System generates alarms continuously until the configuration is corrected.
D. This configuration is common for migrating from WPA to WPA2. No problem is associated with using this configuration.
Answer: B
Q6. Refer to the exhibit.
What is the meaning of the inverted orange triangle (marked "0") in the Alarm Summary tab of Cisco WCS?
A. number of major alarms
B. number of minor alarms
C. number of critical alarms
D. number of system alarms
Answer: A
Q7. You are sitting in an airport preparing to use a free WLAN. When you look at the connections in your Windows 7 wireless client, you see a network name and three boxes with a yellow shield.
What does this mean?
A. You cannot connect to this WLAN.
B. An open ad hoc network is nearby.
C. The WLAN in the airport is open.
D. A secure ad hoc network is nearby.
E. A secure WLAN is in the airport.
F. You must provide a username and password to access the WLAN in the airport.
Answer: B
Q8. Which wireless topology supports roaming?
A. IBSS
B. BSS
C. ESS
D. bridging
Answer: C
Q9. An engineer is trying to identify if radar has impacted the wireless network at a customer site. When using the controller GUI, which dashboard in the Monitor section presents this information?
A. 802.11a/n - Air Quality Reports
B. Clean Air - Worst Air Quality Report
C. 802.11b/g/n - Interfering Devices
D. Statistics - Mobility Statistics
Answer: A
Q10. Refer to the exhibit.
Which action allows you to view a summary count by alarm types for the displayed total of 11 alarms?
A. Choose Monitor > Alarms
B. Click the Security tab
C. Click a respective number in the Alarm Summary
D. Click the Alarm Summary blue arrow
E. Choose Home (house icon) > Alarm Summary
Answer: D
Q11. Refer to the exhibit.
Which tab is used to set up web authentication for guest users?
A. Security > Layer 3
B. Security > Layer 2
C. Security > AAA Servers
D. Advanced
E. General
Answer: A
Q12. An AP using version 7.0 MR1 broadcasts a Layer 3 CAPWAP discovery message on the local IP subnet. Which step does the AP take next?
A. Determine if the controller responses include the primary controller.
B. Determine if the controller responses include the master controller.
C. Send a discovery request using DHCP option 43.
D. Send a discovery request using DNS.
E. Send a discovery request using locally stored information on the AP.
F. Send a discovery request using OTAP.
Answer: E
Q13. An AP was reset while working on the correct association to a Cisco WCS version 7.0.
Which item was cleared during the reset?
A. static IP address
B. the location ID of the AP
C. WLC primary, secondary, tertiary
D. AP name
E. certificate
F. Nothing was cleared.
Answer: F
Q14. During Layer 2 intercontroller roaming, which two items change? (Choose two.)
A. SSID
B. VLAN
C. IP address
D. AP
E. controller
Answer: D,E
Q15. You are testing a new autonomous Cisco Aironet 1260 AP that has booted for the first time on the existing corporate network, which includes voice, data, and location services.
How do you reach the GUI of the AP?
A. HTTP to 10.0.0.1.
B. HTTP to 192.168.1.1.
C. HTTP to the DHCP address.
D. HTTPS to 10.0.0.1.
E. HTTPS to the 192.168.1.1.
F. HTTPS to the DHCP address.
Answer: C