Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. A client’s computer is not connecting to a website. Which of the following commands will allow the technician to view the route/number of hops between the host and remote systems?
A. nbtstat
B. tracert
C. nslookup
D. netstat
Answer: B
Q2. Which of the following would need to be enabled on a mobile phone to share its Internet connection with multiple devices simultaneously?
A. NFC
B. Bluetooth
C. Hotspot
D. Tethering
Answer: C
Q3. Which of the following features is an advantage of a switch over a hub?
A. A switch routes packets instead of frames to different networks.
B. A switch divides bandwidth among connected devices.
C. A switch broadcasts the data frames to every connected device.
D. A switch sends data frames to the correct connected device.
Answer: D
Q4. Which of the following would be the MOST important factor to consider when building a virtualization workstation?
A. High-end graphics card with onboard memory
B. A compact form factor
C. Dual monitor support
D. Maximum RAM and CPU cores
Answer: D
Q5. A technician is working on a laptop with a failed Ethernet port caused by ESD. Which of the following is the simplest solution to restore network connectivity?
A. Re-solder the network connector
B. Replace the Ethernet daughter board
C. Update the Ethernet driver
D. Enable wireless and connect to the WAP
Answer: D
Q6. A technician is troubleshooting an expansion card in a computer that allows the computer to receive faxes over a VoIP line. The line connected to the expansion card is MOST likely which of the following cable types?
A. Coaxial
B. CAT3
C. CAT6
D. Multi-mode fiber
E. Single-mode fiber
Answer: C
Q7. Which of the following is a type of fiber connector?
A. RJ-11
B. F-connector
C. BNC
D. ST
Answer: D
Q8. Joe, a technician, is tasked to install a new client machine. He notices the machine is not getting any network connectivity. He tests the network cable between the PC and the network jack and confirms it is good. Joe goes to the network closet and finds several network cables not connected to the switch. Which of the following tools would Joe use to
determine which cable goes back to the correct network jack?
A. Loopback plug
B. Toner probe
C. WiFi analyzer
D. Punchdown tool
Answer: B
Q9. Which of the following types of expansion slots is MOST frequently found in blade servers?
A. PCIe
B. PCI
C. PCI-X
D. miniPCI
Answer: C
Q10. A company wants to conserve paper without limiting the ability to print. Which of the following settings needs to be configured?
A. Orientation
B. Duplex
C. Collate
D. Quality
Answer: B
Q11. A customer needs a router that will be able to handle all incoming and outgoing networking traffic independent of the rest of the building. The customer would like the PCs to immediately connect to the Internet and network resources without any additional configuration. Which of the following should the technician do to meet the requirements?
A. Configure the router for DHCP.
B. Configure the router for NAT.
C. Configure the router for port forwarding.
D. Configure the router for QoS.
Answer: A
Q12. A technician has connected a laptop to a television via HDMI cable. The entire display cannot be seen on the television. Which of the following settings should the technician modify?
A. Keystone
B. Resolution
C. Privacy filter
D. Frame rate
Answer: B
Q13. A technician needs to set up a VPN for a small office. To ensure the network traffic is routed to the correct machine, which of the following MUST the technician do on the router to accommodate this?
A. Port forwarding
B. Port redundancy
C. Port triggering
D. Port selection
Answer: A
Q14. Which of the following display technologies provides the BEST range of visible colors?
A. CRT
B. LCD
C. Plasma
D. OLED
Answer: D
Q15. The Tower of Hanoi is MOST likely configured in a system which implements:
A. a high RPM drives.
B. a tape drive.
C. an externally attached storage.
D. a RAID configuration.
Answer: B