Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. Which three operations occur during a cold migration of a virtual machine? (Choose three.)
A. The virtual machine disks are moved if the datastore is being changed.
B. The virtual machine is registered with the destination server.
C. The source virtual machine is removed from the old hosts.
D. The virtual machine hardware is upgraded.
E. The virtual machine files are quiesced prior to the migration.
Answer: A,B,C
Q2. When configuring vSphere Replication for a virtual machine, what is the lowest Recovery Point Objective (RPO) that can be selected?
A. 1 min
B. 5 min
C. 10 min
D. 15min
Answer: B
Q3. A vCenter Operations Manager 5.7 environment is upgraded to vRealize Operations. After the upgrade, the analytics services fail to start.
Which three steps must be taken to resolve the problem? (Choose three.)
A. Take the vRealize Operations cluster offline.
B. Delete the activity persistence files.
C. Bring the cluster back online.
D. Remove any unresponsive nodes.
E. Stop the CaSA service.
Answer: A,B,C
Q4. You have just installed an ESXi 6.x Host. As part of your company security regulations, a security banner must be presented on the console of the host.
How can this action be accomplished?
A. Configure the Advanced Settings > Annotations screen of the ESXi host.
B. This is configured from the Direct Console User Interface configuration menu.
C. It is not possible to configure a security banner for the ESXi host.
D. From vCenter Server, this setting is configured globally in the vCenter Server configuration.
Answer: A
Q5. Which two actions are prerequisites to adding ESXi 6.x hosts to a vSphere Distributed Switch? (Choose two.)
A. Verify that there is at least one Distributed Port Group on the Distributed Switch.
B. Verify that the Distributed Port Group have active uplinks configured in its teaming and failover policy.
C. Verify that the Distributed Switch has been configured with a Network Profile.
D. Verify that Network I/O control for Management Traffic is configured for the highest share value.
Answer: A,B
Q6. Refer to the Exhibit. -- Exhibit --
An administrator has been given requirements to configure vMotion for a new virtual machine. The configuration should:
Provide Network Redundancy
Use VLAN 550
Be secured against anyone trying to spoof communication
The vSwitch1 configuration is shown in the Exhibit.
Which three changes should be made to meet the stated requirements? (Choose three.)
A. The VLAN ID must be set appropriately.
B. The default values for MAC Address Changes and Forged Transmits must be altered.
C. The teaming and failover adapters must be set appropriately.
D. The Traffic Shaping configuration must be altered.
E. The Load Balancing Policy must be set appropriately.
Answer: A,B,C
Q7. An administrator wants to add a web server to an existing multi-tier application consisting of three virtual machines: A web server A database server An application server
The web server should be added to the application when the primary web server reaches:
70% vCPU utilization 55% active memory
Which option will achieve this result?
A. Create a virtual machine alarm with an action to run a script that starts a new instance of the web server.
B. Create a host cpu and memory alarm with an action to run a script that starts a new instance of the webserver.
C. Configure HA application monitoring for the web server and set it to trigger deployment of a new instance of the web server.
D. Configure Fault Tolerance on the virtual machine and leave the secondary machine disabled until needed.
Answer: A
Q8. Refer to the Exhibit.
An administrator is configuring an ESXi 6.x host to use multiple NICs to resolve a management network redundancy error. After configuring a second NIC, the server is not able to communicate when the primary connection is taken down. The administrator analyzes the Exhibit shown here.
Based on the exhibit, what is the likely cause of the issue?
A. vmnic4 is not attached to a vSwitch.
B. vmnic2 is not connected to a physical switch.
C. E1000 is the incorrect NIC Driver for this card.
D. There is a MAC address conflict on the network.
Answer: B
Q9. When attempting to access a virtual machine, an administrator is unable to login using the vSphere credentials.
What two options are probable causes of the authentication failure? (Choose two.)
A. The vSphere credentials have not been granted permissions.
B. The vSphere credentials are granted read-only permissions.
C. The vSphere credentials are granted no-access permissions.
D. The vSphere credentials are not a member of the local administrator group.
Answer: A,B
Q10. What is a benefit of using VMware Data Protection (VDP)?
A. Provides support for guest-level backups and restores of Microsoft SQL Servers, Exchange Servers, and Share Point Servers.
B. Provides support for advanced storage services including replication, encryption, deduplication, and compression.
C. Provides direct access to VDP configuration integrated into the vSphere Client.
D. Reduces disk space consumed by virtual machine data using deduplication.
Answer: D
Q11. An ESXi 6.x host consists of 24 logical cores. Hyperthreading is enabled on the host.
What is the maximum number of vCPUs that can be assigned to a virtual machine on this host?
A. 24
B. 48
C. 64
D. 128
Answer: A
Q12. An administrator is deploying multiple Windows 2003 Virtual Machines from the same template.
What two steps should be taken to avoid network conflicts? (Choose two.)
A. Customize the guest operating system.
B. Install VMware Tools into the new virtual machines.
C. Copy the Microsoft Sysprep tools onto the vCenter Server system.
D. Ensure the e1000 vmnic is selected for each new virtual machine.
Answer: A,C
Q13. Which two SMTP Notification Event Details are specific to alarms triggered by events? (Choose two.)
A. User Name
B. Summary
C. Old Status
D. Target
Answer: A,B
Q14. Which three actions can be executed when an alarm is triggered? (Choose three.)
A. Send an email.
B. Send an SNMP trap.
C. Run a script or command.
D. Run an Orchestrator workflow.
E. Send a trigger to syslog.
Answer: A,B,C
Q15. An administrator deploys vRealize Operations into a vSphere 6.x environment. After the deployment, the administrator notices that badges are not appearing.
What is a likely cause of this behavior?
A. Badges do not appear until you register vRealize Operations with vCenter Server.
B. Badges do not appear until you register a vCenter Server in vRealize Operations.
C. The vRealize Operations appliance needs to be redeployed.
D. The vCenter Server appliance needs to be redeployed.
Answer: A
Q16. You are editing the management network configuration of an ESXi 6.x Host from the vSphere Web Client. You mistakenly put the incorrect VLAN in place for the management network.
What action do you need to take to correct this?
A. You need to manually edit the configuration on the host with command line utilities.
B. No action is required. By default ESXi rolls back configuration changes that disconnect the host.
C. The ESXi host system configuration will need to be restored to the factory configuration to fix the issue.
D. The change can be reverted in the vSphere Web Client by simply editing the switch again.
Answer: B