Q1. On what equipment do you configure Layer 2 to Layer 3 QoS mapping?
A. switch
B. router
C. firewall
D. Cisco Unified Communications Manager
E. bridge
Answer: B
Q2. Which three options are types of media resources in CUCM? (Choose three)
A. Music on hold
B. H.323 trunk
C. Media Termination Point
D. Meet-Me Conference
E. SIP trunk F. Transcoder
Answer: A,C,F
Explanation: Reference: Page 295 CIPTV110SG_Vol1
Q3. Which two statements about Cisco VCS Addressing Zones are true? (Choose two.)
A. They can be local to the Cisco VCS or can be remote.
B. A zone is a collection of endpoints that share the same dialing behavior and bandwidth settings.
C. They consist of traversal and nontraversal zones.
D. They can only be local.
E. They consist of subzones such as DNS zones.
Answer: A,B
Q4. If the route patterns 5XXX, 51XX, 513X, and 5134 exist within a call route database, which pattern would be matched if the dialed number was 5124?
A. 5XXX
B. 51XX
C. 513X
D. 5134
Answer: B
Q5. Every VoIP endpoint must select one specific codec. Which of these codecs is the mandatory codec?
A. G.729
B. G.728
C. G.722
D. G.711
E. H.264
Answer: D
Q6. When configuring an H.323 gateway, which configuration option can be used to set whether an incoming call is considered off the network (OffNet) or on the network (OnNet)?
A. call classification
B. call location
C. device pool
D. signaling port
Answer: A
Q7. Which of these media resources can be configured in Cisco Unified Communication manager?
(Choose Three)
A. MOH Server
B. Voice Termination Point DSP
C. Transcoder
D. Auto Attendant
E. Conference Bridge
Answer: A,C,E
Q8. Which DSCP classification is defined in RFC 2474?
A. DSCP CS3.
B. DSCP 0.
C. DSCP AF11.
D. DSCP CS6.
E. DSCP EF.
F. DSCP CS2.
G. DSCP CS1.
H. DSCP AF21.
Answer: A
Explanation: Reference:
Page 24
CIPTV110SG_Vol2
Q9. Which three Cisco Unified Communications Manager settings can be used to support IP phone services? (Choose three.)
A. Device Defaults
B. Enterprise Parameters
C. IP Phone Service Configuration window
D. Common Phone Profile
E. Service Parameters
F. Phone Configuration window
Answer: B,D,F
Q10. Which two codecs are required for Cisco WebEx Enabled TelePresence? (Choose two.)
A. G.711 codec for audio
B. H.264 codec for video
C. G.729 codec for audio
D. G.711 or G.729 codec for audio
E. H.263 codec for video
F. H.264 or H.263 codec for video
Answer: A,B
Q11. Which three statements about the default VoIP dial peer are true? (Choose three.)
A. VAD is disabled.
B. RSVP is not supported.
C. Only the G.711 codec is supported.
D. The G.729 and G.711 codecs are supported.
E. Fax-rate service is supported.
F. DTMF relay is supported.
Answer: B,D,E
Q12. By default, what value is voice traffic marked as on a Cisco Catalyst Switch?
A. DSCP EF value 46, Cos 5.
B. DSCP EF value 46, Cos 7.
C. DSCP CAS6 value 21, Cos 3.
D. DSCP AF21, Cos 5.
Answer: A
Q13. If no SIP dial rules are configured on an IP phone, at which three points in the collection of digits does a Type A SIP phone send digits to the Cisco Unified Communications
Manager? (Choose three.)
A. when the interdigit timer expires
B. when the collected digits match a SIP dial rule
C. when the user presses the Dial softkey
D. as each digit is collected (it is sent for analysis)
E. when the user presses the # key
Answer: A,C,E
Q14. What are two characteristics that are associated with the End User and User account types? (Choose two.)
A. They cannot use LDAP.
B. They are used to authorize applications.
C. They can utilize LDAP.
D. The Application is associated with the End User and User account types.
E. They can be listed in a directory.
Answer: C,D
Q15. Which statement about a partition is true?
A. A partition is a logical group of transformation patterns with similar accessibility characteristics.
B. A partition is a group of gateways with similar accessibility characteristics.
C. A partition is a logical group of directory numbers with similar accessibility characteristics.
D. A partition is a logical group of route patterns with similar accessibility characteristics.
Answer: C
Explanation: Reference:
http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-managercallmanager/13920-call-routing.html