Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. Which three items must you configure to enable SAF Call Control Discovery? (Choose three.)
A. the SIP or H.323 trunk
B. hosted DN groups
C. hosted DN patterns
D. route patterns
E. a calling search space
F. translation patterns
Answer: A,B,C
Q2. Which three options are overlapping parameters for roaming when a device is configured for Device Mobility? (Choose three.)
A. MRGL
B. location
C. network locale
D. codec
E. extension
F. device pool
Answer: A,B,C
Q3. What is the standard Layer 3 DSCP media packet value that should be set for Cisco TelePresence endpoints?
A. CS3 (24)
B. EF (46)
C. AF41 (34)
D. CS4 (32)
Answer: D
Q4. During device failover to the secondary Cisco Unified Communications Manager server, how does the phone recognize that the primary server is back?
A. The secondary server keeps sending keepalive message to the primary server and when it succeeds, it unregisters the phones to force them to register to the primary.
B. When the primary server goes online, it sends out an "ALIVE" message via broadcast so that the phones re-register.
C. The phones never re-register with the primary server until the active (secondary) one goes down.
D. The phone sends keepalive messages to the primary server frequently and when it succeeds, the phone re-registers with it.
Answer: D
Q5. A Cisco Unified Communications Manager cluster is installed in headquarters only.
How can international calls be blocked while national calls are allowed for branch office Cisco IP Phones during a WAN failure?
A. Configure CSS and partitions in Cisco Unified Communications Manager and apply the CSS and partitions to the SRST ISR.
B. Configure CSS and partitions in the SRST ISR.
C. Configure COR in the SRST ISR.
D. Configure voice translations in the SRST ISR.
Answer: C
Q6. Which two configurable options are available to enable Early Offer for calls over a Cisco Unified Communications Manager SIP trunk? (Choose two.)
A. No Media Termination Point Required
B. Media Termination Point Required
C. Accept Audio Codec Preferences in Received Offer
D. Early Offer support for voice and video calls Mandatory (insert MTP if needed)
E. Use Trusted Relay Point
Answer: B,D
Q7. When an incoming PSTN call arrives at an MGCP gateway, how does the calling number get normalized to a global E.164 number with the + prefix in Cisco Unified Communications Manager?
A. Normalization is done using translation patterns.
B. Normalization is done using route patterns.
C. Normalization is done using the gateway incoming called party prefixes based on number type.
D. Normalization is done using the gateway incoming calling party prefixes based on number type.
E. Normalization is achieved by local route group that is assigned to the MGCP gateway.
Answer: D
Explanation:
Incorrect Answer: A, B, C, E Configuring calling party normalization alleviates issues with toll bypass where the call is routed to multiple locations over the IP WAN. In addition, it allows Cisco Unified Communications Manager to distinguish the origin of the call to globalize or localize the calling party number for the phone user. Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmfeat/fscallpn.html
Q8. The VCS Expressway can be configured with security controls to safeguard external calls and endpoints. One such option is the control of trusted endpoints via a whitelist. Where is this option enabled?
A. on the voice-enabled firewall at the edge of the network
B. on the VCS under Configuration > registration > configuration
C. on the TMS server under Registrations > whitelist
D. on the VCS under System > configuration > Registrations
Answer: B
Q9. What is the purpose of configuring a hardware-based MTP when deploying Cisco Unified Communications Manager?
A. to allow for supplementary services such as hold, transfer, and conferencing
B. when you need support for up to 24 MTP sessions on the same server and 48 on a separate server
C. when you need the ability to grow support by using DSPs
D. when you want to only use Cisco Unified Communications Manager resources
Answer: C
Q10. Which option best describes a service that assembles a network model from configured locations and link data in one or more clusters?
A. LBM
B. Weight
C. LBM Hub
D. Shadow
Answer: A
Q11. Which statement about SIP precondition is most correct?
A. When configuring SIP precondition, the SIP trunk must have access to an RSVP agent.
B. When configuring SIP precondition, the IP phones must have access to an RSVP agent.
C. When configuring SIP precondition, the IP phones and SIP trunk must have access to an RSVP agent.
D. RSVP agents are only required for the IP phones. SIP trunks require RSVP agents only when fall back to local RSVP is configured.
E. SIP trunk will always require RSVP agents regardless of what RSVP type is configured.
Answer: D
Q12. Refer to the exhibit.
Assuming the regions configuration to BR only permits G.729 codec, how many calls are allowed for the BR location?
A. Total of four calls; two incoming and two outgoing.
B. Total of two calls in either direction.
C. Total of four calls to the BR location. Outgoing calls are not impacted by the location configuration.
D. Total of four calls in either direction.
E. Two outgoing calls. Incoming calls are unlimited.
Answer: D
Explanation:
Incorrect Answer: A, B, C, E In performing location bandwidth calculations for purposes of call admission control, Cisco Unified Communications Manager assumes that each G.729 call stream consumes 24 kb/s amount of bandwidth Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a02cac.html #wpxref28640
Q13. Which two statements describe RSVP-enabled locations-based CAC? (Choose two.)
A. RSVP can be enabled selectively between pairs of locations.
B. Using RSVP for CAC simply allows admitting or denying calls based on a logical
configuration that is ignoring the physical topology.
C. RSVP is topology aware, but only works with full mesh networks.
D. An RSVP agent is a Media Termination Point that the call has to flow through.
E. RSVP and RTP are used between the two endpoints.
Answer: A,D
Explanation:
Incorrect Answer: B, C The RSVP policy that is configured for a location pair overrides the default interlocation RSVP policy that configure in the Service Parameter Configuration window. RSVP supports audio, video, and data pass-through. Video data pass-through allows video and data packets to flow through RSVP agent and media termination point devices Link: https://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a02rsvp.ht ml#wp1070214
Q14. Which three options are supplementary services that are affected by MTP? (Choose three.)
A. Call Hold
B. Call Transfer
C. Call Park
D. Call Pickup
E. Speed Dial
F. Call Back
Answer: A,B,C
Q15. When considering Extension Mobility, what happens if a user logs into a phone for which the user does not have a user device profile?
A. The phone reboots with an error.
B. If a default device profile for this phone has been configured, it is loaded.
C. The user cannot log in.
D. Another user device profile is loaded.
Answer: B