Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. Which remote-site redundancy technology fails over to POTS dial peers from the Cisco Unified Communications Manager dial plan during a WAN failure?
A. MGCP fallback
B. H.323 fallback
C. SCCP fallback
D. SIP fallback
Answer: A
Q2. Which three devices support the SAF Call Control Discovery protocol? (Choose three.)
A. Cisco Unified Border Element
B. Cisco Unity Connection
C. Cisco IOS Gatekeeper
D. Cisco Catalyst Switch
E. Cisco IOS Gateway
F. Cisco Unified Communications Manager
Answer: A,E,F
Q3. Which bandwidth amounts are correct for configuring locations?
A. 8 kb/s for G.729, 64 kb/s for G.711, and 64 kb/s for G.722
B. 8 kb/s for G.729, 64 kb/s for G.711, and 16 kb/s for G.722
C. 64 kb/s for G.729, 64 kb/s for G.711, and 64 kb/s for G.722
D. 8 kb/s for G.729, 8 kb/s for G.711, and 8 kb/s for G.722
Answer: A
Q4. A Cisco 3825 needs to be added in Cisco Unified Communications Manager as an H.323 gateway. What should the gateway type be?
A. H.323 gateway
B. Cisco 3825
C. Cisco 3800 series router. The specific model will be selected after the Cisco 3800 is selected.
D. The gateway can be added either as an H.323 gateway or Cisco 3800 series router.
E. The gateway can be added either as an H.323 gateway or Cisco 3825 series router.
Answer: A
Q5. Which two options must be selected in the SIP Trunk Security Profile configuration between Cisco Unified Communications Manager and Expressway? (Choose two)
A. Enable application-level authorization
B. Accept presence subscription
C. Accept out-of-dialog refer
D. Accept unsolicited notification
E. Accept replaces header
F. Transmit security status
G. Allow charging header
Answer: D,E
Q6. Assume that the Cisco IOS SAF Forwarder is configured correctly. Which minimum configurations on Cisco Unified Communications Manager are needed for the SAF registration to take place?
A. SAF Trunk, SAF Security Profile, SAF Forwarder, and CCD Advertising Service
B. SAF Trunk, SAF Security Profile, SAF Forwarder, and CCD Requesting Service
C. SAF Trunk, SAF Security Profile, SAF Forwarder, CCD Requesting Service, and CCD Advertising Service
D. SAF Trunk, SAF Security Profile, and SAF Forwarder
E. SAF Trunk, CCD Requesting Service, and CCD Advertising Service
Answer: B
Q7. When Cisco Extension Mobility is implemented, how is the audio source for the MOH selected?
A. The audio source that is configured at the user device profile is selected.
B. The audio source that is configured at the home phone of the user is selected.
C. The audio source that is configured at the physical phone used for the Cisco Extension Mobility login is selected.
D. The audio source that is configured in the IP Voice Media Streaming parameters is selected.
Answer: A
Explanation:
Incorrect Answer: B, C, D To specify the audio source that plays when a user initiates a hold action, choose an audio source from the User Hold MOH Audio Source drop-down list box from device profile configuration settings. Link: http://cisco.biz/en/US/docs/voice_ip_comm/cucmbe/admin/8_6_1/ccmcfg/b06dvprf.html
Q8. You have been asked to deploy Cisco Extension Mobility Cross Cluster for a distributed call processing environment. During the initial extension mobility login request, how does the visiting cluster determine if the user is a local user or a remote user?
A. by using a third-party automatic provisioning tool to verify user ID
B. by broadcasting a request to all clusters to verify the user type
C. from user IDs that are created by default when the user logs in
D. by using Extension Mobility Cross Cluster Session Initiation Protocol (SIP) trunks
E. by verifying against the local database
F. by verifying the visiting Trivial File Transfer Protocol
Answer: E
Q9. Cisco Unified Communications Manager is configured with CAC for a maximum of 10 voice calls.
Which action routes the 11th call through the PSTN?
A. Configure an SIP trunk to the ISR.
B. Configure Cisco Unified Communications Manager AAR.
C. Configure Cisco Unified Communications Manager RSVP-enabled locations.
D. Configure Cisco Unified Communications Manager locations.
Answer: B
Q10. When an incoming PSTN call arrives at an H.323 gateway, how does the calling number get normalized to a global E.164 number with + prefix in Cisco Unified Communications Manager?
A. Normalization is done using translation patterns.
B. Normalization is done using route patterns.
C. Normalization is done using the gateway incoming called party prefixes based on number type.
D. Normalization is done using the gateway incoming calling party prefixes based on number type.
E. Normalization is achieved by local route group that is assigned to the H.323 gateway.
Answer: D
Q11. To preserve analog calls in an MGCP switchback event, which three commands must be configured in the MGCP fallback router? (Choose three.)
A. h323
B. mgcp-switchback-graceful
C. voice service voip
D. mgcp-graceful
E. preserve-h323
F. no h225 timeout keepalive
Answer: A,C,F
Explanation:
Incorrect Answer: B, D, E these additional command for call preservation when using MGCP fallback: voice service voip h323 no h225 timeout keepalive Reference. CCNP Voice CIPT2 642-457 Quick Reference, 2nd Edition
Q12. Which statement about the host portion format in Cisco Unified Communications Manager URI dialing is false?
A. The host portion cannot start or end with a hyphen.
B. The host portion is not case sensitive.
C. The host portion accepts characters a-z, A-Z, 0-9, hyphens, and periods.
D. The host portion can have two periods in a row.
Answer: D
Q13. Which two statements are true regarding the implementation of globalized call-routing in terms of localized call egress? (Choose two.)
A. Calling-party numbers are routed from the gateway or trunks to phones.
B. Called-party numbers are routed from the gateway or trunks to phones.
C. Calling-party numbers of internal calls are routed from the gateway or trunks.
D. Calling-party calls are routed to the gateway and trunks.
Answer: A,D
Q14. The relationship between a Region and a Location is that the Region codec parameter is combined with Location bandwidth when communicating with other Regions.
A. FALSE
B. TRUE
Answer: A
Explanation:
Locations work in conjunction with regions to define the characteristics of a network link. Regions define the type of compression (G.711, G.722, G.723, G.729, GSM, or wideband) that is used on the link, and locations define the amount of available bandwidth for the link Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a02cac.html #wp1033331
Q15. Refer to the exhibit.
Which trunks would be most suitable for Connection Y?
A. an H.225 trunk (gatekeeper-controlled)
B. intercluster trunk (gatekeeper-controlled)
C. a SIP trunk on the U.S. cluster and an intercluster trunk on the remote cluster
D. intercluster trunk (nongatekeeper-controlled)
E. No extra connections are required. As long as IP connectivity exists, you need only configure a route pattern for each site. The Cisco Unified Communications Manager will automatically forward the calls over the WAN if the destination directory number is not registered locally.
Answer: D