Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. Which process can localize a global E.164 with + prefix calling numbers for inbound calls to an IP phone so that users see the calling number in a local format?
A. Calling number localization is done using translation patterns.
B. Calling number localization is done using route patterns.
C. Calling number localization is done by configuring a calling party transformation CSS at the phone.
D. Calling number localization is done by configuring a calling party transformation CSS at the gateway.
E. Calling number localization is done by configuring the phone directory number in a localized format.
Answer: C
Q2. Which technologies provide remote-site redundancy for Cisco IP Phones during a WAN failure?
A. SRST and MGCP fallback
B. SRST and TEHO
C. TEHO and MGCP fallback
D. SRST and AAR
Answer: A
Q3. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phones. The Cisco VCS and TMS control the Cisco TelePresence Conductor, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
DNS Servers
Device Pool
Expressway
ILS
Locations
MRA
Speed Dial
SIP Trunk
What two tasks must be completed in order to support calls between the VCS controlled endpoints and the Cisco Unified CM endpoints? (Choose two.)
A. Media Resource Group List.
B. Configure a SIP trunk on the Cisco Unified CM to point to the Cisco VCS.
C. Configure a neighbor zone on the Cisco Unified CM to point to the Cisco VCS.
D. Configure a SIP trunk on the Cisco VCS to point to the Cisco Unified CM.
E. Configure a neighbor zone on the Cisco VCS to point to the Cisco Unified CM.
Answer: B,D
Q4. Which three configuration settings are included in a default region configuration? (Choose three.)
A. Audio Codec
B. Video Call Bandwidth
C. Link Loss Type
D. Location Description
E. Immersive Bandwidth
F. Real Time Protocol
Answer: A,B,C
Q5. Which option indicates the best QoS parameters for interactive video?
A. 1% Max Loss, 150 ms One-way Latency, 30 ms Jitter, 20% Overprovisioning
B. 5% Max Loss, 5 s One-way Latency, 30 ms Jitter, 20% Overprovisioning
C. 0% Max Loss, 100 ms One-way Latency, 30 ms Jitter, 20% Overprovisioning
D. 1% Max Loss, 160 ms One-way Latency, 60 ms Jitter, 10% Overprovisioning
Answer: A
Q6. The following exhibit shows configs for H.323 gateway. You have been asked to implement TEHO from a remote branch office with area code 301 to the HQ office with area code 201 using Cisco Unified Communications Manager. The remote office has an MGCP gateway and the HQ office has an H.323 gateway. Once the call arrives at the HQ, it should break out to the PSTN as a seven-digit local call. Which statement about the route pattern is true?
A. route pattern should be 91201.[2-9]XXXXXX with Discard Digit as Predot and Prefix 9
B. route pattern should be 91201.[2-9]XXXXXX with Discard Digit as Predot
C. route pattern should be 91201.[2-9]XXXXXX
D. route pattern should be 9.1201[2-9]XXXXXX with Discard Digit as Predot
E. route pattern should be 9.1201[2-9]XXXXXX with Discard Digit as Predot and Prefix 9
Answer: A
Explanation:
Incorrect Answer: B, C, D, E
Destination pattern is 91, HQ office area code is 201 .
Q7. Refer to the exhibit.
What should the destination IP address be configured as on the HQ and BR1 SIP trunks?
A. The HQ SIP trunk destination IP address should be 10.1.6.10. The BR1 SIP trunk destination IP address should be 10.1.5.10.
B. The destination IP address is not configurable. Each cluster will learn about the remote trunk IP address through SAF learned routes.
C. The destination IP address will be learned automatically and configured on the SIP trunks after the Cisco Unified Communications Managers discover themselves.
D. The HQ SIP trunk destination IP address should be the HQ SAF Forwarder IP address. The BR1 SIP trunk destination IP address should be the BR1 SAF Forwarder IP address.
Answer: B
Explanation:
Incorrect Answer: A, C, D
The gatekeeper changes the IP address of this remote device dynamically to reflect the IP address of the remote device.
Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a08trnk.html
Q8. Refer to the exhibit.
How many calls can be placed to Cluster B?
A. three G.729 calls
B. one G.711 call
C. one G.711 and three G.729 calls
D. There is no limit for incoming calls to Cluster B. Outgoing calls are limited to one G.711 and three G.729 calls.
Answer: A
Q9. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phone. The Cisco VCS is controlling the SX20, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
DP
Locations
CSS
Movi Failure
Movi Settings
CIPTV Topo
Subzone
Links
Pipe
A third collaboration call fails between the backbone site and the HQ site. After reviewing the exhibits, which of the following reasons could be causing this failure?
A. Not enough bandwidth has been allocated.
B. Device Pool.
C. Location.
D. The pipe is not functioning.
Answer: A
Explanation:
Based on the exhibit, each call is limited to no more than 128kbps per call, but the total available bandwidth is set to 256 kbps. This will allow the first to calls to go through, but there will be no more available bandwidth for the third call.
Q10. Refer to the exhibit.
You have configured transcoder resources in both an IOS router and a Cisco Unified Communications Manager. When you review the configurations in both devices the IP addresses and transcoder names are correct, but the transcoder is failing to register with the Cisco Unified Communications Manager. Which command needs to be edited to allow the transcoder to register properly?
A. The associate profile and dsp farm profile numbers need to match associate ccm 2 command.
B. The associate ccm 2 priority 1 command needs to be changed so the ccm value matches identifier 1 in the sccp ccm 10.1.1.1 command.
C. The sccp ccm group number needs to match the associate ccm 2 command.
D. The maximum sessions command must match the number of codecs configured under the dsp farm profile.
E. The sccp ccm group number must match the voice-card number.
Answer: B
Explanation:
Incorrect Answer: A, C, D, E The value of the IP address should match the IP address in the ip source-address command Link:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmevtr ns.html
Q11. In the case of a VCS cluster, which configuration element is recommended for endpoint H.323 registration?
A. DNS SRV records pointing to the VCS cluster name
B. static IP addresses
C. hostname of the VCS cluster configuration master
D. hostname of the VCS cluster member peer
Answer: A
Q12. When Cisco Extension Mobility is implemented, which CSS is used for calling privileges?
A. The user device profile line CSS combined with the device CSS of the physical phone used to log in the extension mobility user.
B. The user device profile device CSS combined with the line CSS of the physical phone used to log in the extension mobility user.
C. Only the user device profile device CSS is used.
D. The combined line/device CSS of the physical phone is used to log in the extension mobility user.
E. The combined line/device CSS of the user device profile.
Answer: A
Q13. Which two configurations are needed to implement SRST in Cisco Unified Communications Manager? (Choose two.)
A. SRST Gateway setting in Cisco Unified Communications Manager
B. SRST Reference configured in Cisco Unified Communications Manager
C. Device Pool SRST Reference setting
D. Call Manager Group setting
E. Cisco Unified Communications Locations setting
Answer: B,C
Q14. On which Cisco Unified Communications Manager configuration parameter does the CODEC that a Cisco IP Phone uses for a call depend?
A. enterprise parameters
B. media resources
C. physical location
D. region
E. location
Answer: D
Q15. Scenario
There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phones. The Cisco VCS and TMS control the Cisco TelePresence Conductor, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
Use the exhibits to answer the following questions.
DNS Servers
Device Pool
Expressway
ILS
Locations
MRA
Speed Dial
SIP Trunk
Which three configuration tasks need to be completed on the router to support the registration of Cisco Jabber clients? (Choose three.)
A. The DNS server has the wrong IP address.
B. The internal DNS Service (SRV) records need to be updated on the DNS Server.
C. Flush the DNS Cache on the client.
D. The DNS AOR records are wrong.
E. Add the appropriate DNS SRV for the Internet entries on the DNS Server.
Answer: B,C,E