Cisco 300-101 Free Practice Questions

New Questions 3

Refer to exhibit:

Why is the default route not removed when 172.20.20.2 stops replying to ICMP echos?

A. The source-interface is configured incorrectly.

B. the threshold value is wrong

C. The destination must be 172.30.30.2 for icmp-echo.

D. The default route is missing the track feature.

View Answer

New Questions 4

What is IPv6 router solicitation?

A. a request made by a node to join a specified multicast group

B. a request made by a node for its IP address

C. a request made by a node for the IP address of the DHCP server

D. a request made by a node for the IP address of the local router

View Answer

New Questions 5

A network engineer enables OSPF on a Frame Relay WAN connection with circuit-id 28468340 to various remote sites, but no OSPF adjacencies come up. Which two actions are possible solutions for this issue? (Choose Two)

A. Change the network type to point-to-multipoint under WAN interface.

B. Enable virtual links.

C. Change the network type to nonbroadcast multipoint access.

D. Configure the neighbor command under OSPF process for each remote site.

E. Ensure that the OSPF process number matches among all remote sites

View Answer

New Questions 6

A network administrator is troubleshooting a DMVPN setup between the hub and the spoke. Which action should the administrator take before troubleshooting the IPsec configuration?

A. Verify the GRE tunnels.

B. Verify ISAKMP.

C. Verify NHRP.

D. Verify crypto maps.

View Answer

New Questions 7

Which statement is true?

A. RADIUS uses TCP, and TACACS+ uses UDP.

B. RADIUS encrypts the entire body of the packet.

C. TACACS+ encrypts only the password portion of a packet.

D. TACACS+ separates authentication and authorization.

View Answer

New Questions 8

An engineer executes the ip flow ingress command in interface configuration mode. What is the result of this action?

A. It enables the collection of IP flow samples arriving to the interface.

B. It enables the collection of IP flow samples leaving the interface.

C. It enables IP flow while disabling IP CEF on the interface.

D. It enables IP flow collection on the physical interface and its subinterfaces.

View Answer

New Questions 9

Refer to the exhibit.

Which option represents the minimal configuration that allows inbound traffic from the 172.16.1.0/24 network to successfully enter router R, while also limiting spoofed 10.0.0.0/8 hosts that could enter router R?

A. (config)#ip cef (config)#interface fa0/0

(config-if)#ip verify unicast source reachable-via rx allow-default

B. (config)#ip cef

(config)#interface fa0/0

(config-if)#ip verify unicast source reachable-via rx

C. (config)#no ip cef (config)#interface fa0/0

(config-if)#ip verify unicast source reachable-via rx

D. (config)#interface fa0/0

(config-if)#ip verify unicast source reachable-via any

View Answer

New Questions 10

What option can be used for uRPF in loose mode on the command? ip verify unicast source reachable-via

A. rx

B. any

C. allow-default

View Answer

New Questions 11

An engineer is asked to monitor the availability of the next-hop IP address of 172.16.201.25 every 3 seconds using an ICMP echo packet via an ICMP echo probe. Which two commands accomplish this task? (Choose two.)

A. router(config-ip-sla)#icmp-echo 172.16.201.25 source-interface FastEthernet 0/0

B. router(config-ip-sla-echo)#timeout 3

C. router(config-ip-sla)#icmp-jitter 172.16.201.25 interval 100

D. router(config-ip-sla-echo)#frequency 3

E. router(config-ip-sla)#udp-echo 172.16.201.25 source-port 23

F. router(config-ip-sla-echo)#threshold 3

View Answer

New Questions 12

Which two commands must you configure on a DMVPN hub to enable phase 3? (Choose two)

A. ip nhrp interest

B. ip nhrp redirect

C. ip nhrp shortcut

D. ip network-id

E. ip nhrp map

F. ip redirects

View Answer