Cisco 300-101 Free Practice Questions

Question No: 4

Which statement about dual stack is true?

A. Dual stack translates IPv6 addresses to IPv4 addresses.

B. Dual stack means that devices are able to run IPv4 and IPv6 in parallel.

C. Dual stack translates IPv4 addresses to IPv6 addresses.

D. Dual stack changes the IP addresses on hosts from IPv4 to IPv6 automatically.

View Answer

Question No: 5

Refer to the exhibit. The command is executed while configuring a point-to-multipoint Frame Relay interface. Which type of IPv6 address is portrayed in the exhibit?

A. link-local

B. site-local

C. global

D. multicast

View Answer

Question No: 6

Which IP SLA operation can be used to measure round-trip delay for the full path and hop- by-hop round-trip delay on the network?

A. HTTP

B. ICMP path echo

C. TCP connect

D. ICMP echo

View Answer

Question No: 7

Refer to the exhibit.

A network engineer is troubleshooting a DMVPN setup between the hub and the spoke. The engineer executes the command show crypto isakmp sa and observes the output that is displayed. What is the problem?

A. That ISAKMP is not enabled

B. That ISAKMP is using default settings

C. An incompatible IP sec transform set

D. An incompatible ISAKMP policy

View Answer

Question No: 8

The enterprise network WAN link has been receiving several denial of service attacks from both IPv4 and IPv6 sources. Which three elements can you use to identify an IPv6 packet via its header, in order to filter future attacks? (Choose three.)

A. Traffic Class

B. Source address

C. Flow Label

D. Hop Limit

E. Destination Address

F. Fragment Offset

View Answer

Question No: 9

In which scenario can asymmetric routing occur?

A. active/active firewall setup

B. single path in and out of the network.

C. active/standby firewall setup

D. redundant routers running VRRP

View Answer

Question No: 10

Which option must be configured on a target device to use time stamping to accurately represent response times using IP SL ?

A. Responder

B. Jitter value

C. TCP Connect

D. ICMP Echo

View Answer

Question No: 11

A router was configured with the eigrp stub command. The router advertises which types of routes?

A. connected, static, and summary

B. static and summary

C. connected and static

D. connected and summary

View Answer

Question No: 12

What command is needed to get the ip address assigned from the PPPOE server?

A. Interface dialer

B. pppoe enable

C. ip address negotiated

D. ip address auto negotiated

View Answer

Question No: 13

What are three reasons to control routing updates via route filtering? (Choose three).

A. to hide certain networks from the rest of the organization

B. for easier implementation

C. to control network overhead on the wire

D. for simple security

E. to prevent adjacencies from forming

View Answer