Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
P.S. Simulation 300-101 faq are available on Google Drive, GET MORE: https://drive.google.com/open?id=1IPFRgHPm2o-6qCPBhQuk3ypuFkiGdV3b
Q12. Refer to following:
router eigrp 1
redistribute ospf 1 route-map ospf-to-eigrp default-metric 20000 2000 255 1 1500
!
route-map ospf-to-eigrp deny 10 match tag 6
match route-type external type-2
!
route-map ospf-to-eigrp permit 20 match ip address prefix-list pfx
set metric 40000 1000 255 1 1500
!
route-map ospf-to-eigrp permit 30 set tag 8
Which three statements accurately describe the result of applying the exhibited route map?
A. The map prohibits the redistribution of all type 2 external OSPF routes with tag 6 set.
B. The map prohibits the redistribution of all type 2 external OSPF routes.
C. The map redistributes into EIGRP all routes that match the pfx prefix list and the five metric values 40000, 1000, 255, 1, and 1500.
D. The map prohibits the redistribution of all external OSPF routes with tag 6 set.
E. All routes that do no match clauses 10 and 20 of the route map are redistributed with their tags set to 8.
F. The map permits the redistribution of all type 1 external OSPF routes.
Answer: A,E,F
Q13. What is the primary service that is provided when you implement Cisco Easy Virtual Network?
A. It requires and enhances the use of VRF-Lite.
B. It reduces the need for common services separation.
C. It allows for traffic separation and improved network efficiency.
D. It introduces multi-VRF and label-prone network segmentation.
Answer: C
Q14. Using new backup router in spite of faulty one in ospf domain but relationship with neighbour in one interface only not working , what is the reason of this problem?(choose 2)
A. area Id mismatch
B. authentication mismatch
C. process id of ospf not match
D. ospf timers not match
Answer: A,B
Q15. Which NAT Command to disable dynamic ARP learning on an interface?
A. R(config-if) # ip nat enable
B. R(config-if) # ip nat inside
C. R(config-if)# ip nat outside
D. R(config)# ip nat service
E. R(config)# ip nat allow static host
Answer: E
Q16. Refer to the exhibit. On the basis of the output from the show ipv6 interface command, what two statements must be true? (Choose two.)
A. Interface Ethernet 0/0 was configured with the ipv6 ospf 1 area 1 command.
B. Interface Ethernet 0/0 has been configured with the ipv6 ospf authentication ipsec spi 500 md5 command.
C. OSPF version 3 is enabled to support IPv6.
D. The IP address of the designated router (DR) is FE80::A8BB:CCFF:FE00:6E00.
E. This is the designated router (DR) on the Ethernet 0/0 link.
Answer: B,C
Q17. Which two addresses types are included in NAT?
A. inside global
B. global outside
C. outside internet
D. inside internet
E. outside local
Answer: A,E
Q18. In a point-to-multipoint Frame Relay topology, which two methods ensure that all routing updates are received by all EIGRP routers within the Frame Relay network? (Choose Two)
A. Use statically defined EIGRP neighbors on the hub site.
B. Create separate address families.
C. Disable split horizon.
D. Use sub interfaces.
E. Disable EIGRP auto summary.
Answer: A,C
Q19. Which statement about the NPTv6 protocol is true?
A. It is used to translate IPv4 prefixes to IPv6 prefixes.
B. It is used to translate an IPv6 address prefix to another IPv6 prefix.
C. It is used to translate IPv6 prefixes to IPv4 subnets with appropriate masks.
D. It is used to translate IPv4 addresses to IPv6 link-local addresses.
Answer: B
Q20. Which statement is a restriction for PPPoE configuration?
A. Multiple PPPoE clients can use the same dialer interface.
B. Multiple PPPoE clients can use the same dialer pool.
C. A PPPoE session can be initiated only by the client.
D. A PPPoE session can be initiated only by the access concentrator.
Answer: C
Q21. What is the purpose of configuring the router as a PPPoE client?
A. to provide VPN access over L2TP
B. to enable PPP session from the router to the termination device at the headend for metroEthernet connectivity
C. for DSL connectivity and removing the need for the end-user PC to run the PPPoE client software
D. for connecting the router to a cable modem, which bridges the Ethernet frames from the router to the cable modem termination system
Answer: C
Explanation:
DSL Technology used PPPoE protocol (service provide end) and user end required to be used same Protcol running as client to communicate with it
P.S. Easily pass 300-101 Exam with Examcollectionplus Simulation Dumps & pdf vce, Try Free: https://www.examcollectionplus.net/vce-300-101/ (487 New Questions)