P.S. Certified 300-115 guidance are available on Google Drive, GET MORE: https://drive.google.com/open?id=1WzeEi-YMJ4-9dZHT1BGDd5p41JZ_7zCqNew Cisco 300-115 Exam Dumps Collection (Question 13 - Question 23)Question No: 13Which two statements apply to topology-based switching?A. It is functionally equivalent to Cisco Express ForwardingB. It is the preferred switching mode in Cisco multilayer switchesC. It uses Loop free protocol for switchingD. disabled by defaultView AnswerAnswer: A,BQuestion…
P.S. Downloadable 300-115 ebook are available on Google Drive, GET MORE: https://drive.google.com/open?id=1nqmTzPBxJcHOIojlwmCwStAmAEYMwbkCNew Cisco 300-115 Exam Dumps Collection (Question 8 - Question 18)New Questions 8Which statement describes what happens if all VSL connections between the virtual switch members are lost?A. Both virtual switch members cease to forward traffic.B. The VSS transitions to the dual active recovery mode, and both virtual switch…
P.S. Highest Quality 300-115 training tools are available on Google Drive, GET MORE: https://drive.google.com/open?id=1rTlkzumKqp-6l1APdN9gEEYnSmQquTdNNew Cisco 300-115 Exam Dumps Collection (Question 2 - Question 11)Question No: 2EtherChannel load balancing with an exhibit. SERVER SERVER| |S W I T C H|||||||||||S W I T C H| HOSTWhich EtherChannel load balancing algorithm should be used to optimize the EtherChannel linksbetween switches?A. Source MACB.…
P.S. Validated 300-115 free demo are available on Google Drive, GET MORE: https://drive.google.com/open?id=1rTlkzumKqp-6l1APdN9gEEYnSmQquTdNNew Cisco 300-115 Exam Dumps Collection (Question 8 - Question 17)Question No: 8Which IOS configuration command is required to configure a VLAN as a private VLAN?A. switch(config-vlan)# private-vlan commonB. switch(config-vlan)# private-vlan privateC. switch(config-vlan)# private-vlan primaryD. switch(config-vlan)# private-vlan transparentView AnswerAnswer: CQuestion No: 9Which two DTP negotiated interface mode combinations…
P.S. Exact 300-115 free demo are available on Google Drive, GET MORE: https://drive.google.com/open?id=1WzeEi-YMJ4-9dZHT1BGDd5p41JZ_7zCqNew Cisco 300-115 Exam Dumps Collection (Question 14 - Question 23)Q14. A switch has been configured with the Vlan dot1q tag native command. Which statement describes what the switch does with untagged frames that it receives on a trunked interface?A. Untagged frames are forwarded via the default VLANB.…
P.S. Guaranteed 300-115 paper are available on Google Drive, GET MORE: https://drive.google.com/open?id=18vBmk6S7TFCKhZwKBGhuuThdM-QUxSR-New Cisco 300-115 Exam Dumps Collection (Question 11 - Question 20)Question No: 11A network is considering implementing UDLD throughout the network. Which option must the network engineer consider?A. UDLD work at Layer 1 of the OSI model.B. UDLD aggressively disables the port after eight failed retries to connect to…
P.S. Best Quality 300-115 secret are available on Google Drive, GET MORE: https://drive.google.com/open?id=1CfKI5pbjCPmPD71IOn4nWDyRdJ9zMspQNew Cisco 300-115 Exam Dumps Collection (Question 3 - Question 12)Question No: 3Refer to the exhibit. Based upon the output of show vlan on switch CAT2, what can we conclude about interfaces Fa0/13 and Fa0/14?A. That interfaces Fa0/13 and Fa0/14 are in VLAN 1B. That interfaces Fa0/13 and…
Q1. A network engineer configured an Ethernet switch using these commands. Switchone(config) # Spanning-tree portfast bpdufilter defaultWhich statement about the spanning-tree portfast feature on the switch is true?A. If an interface is enabled for portfast receives BDPU, the port goes through the spanning-tree listening, learning, and forwarding states.B. If an interface is enabled for portfast receives BDPU, the port does…
Q1. Which feature describes MAC addresses that are dynamically learned or manually configured, stored in the address table, and added to the running configuration?A. stickyB. dynamicC. staticD. secureView AnswerAnswer: AQ2. An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the EtherChannel links is being utilized to…
Q1. A network engineer is installing a switch for temporary workers to connect to. The engineer does not want this switch participating in Spanning Tree with the rest of the network; however, end user connectivity is still required. Which spanning-tree feature accomplishes this?A. BPDUblockB. BPDUfilterC. BPDUignoreD. BPDUguardE. BPDUdisableView AnswerAnswer: BQ2. An access switch has been configured with an EtherChannel port.…
Q1. Which option is a benefit of using VSS?A. reduces costB. simplifies configurationC. provides two independent supervisors with two different control planesD. removes the need for a First Hop Redundancy ProtocolView AnswerAnswer: DQ2. Refer to the exhibit.The network switches for two companies have been connected and manually configured for the required VLANs, but users in company A are not able…
Q1. Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.• DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105• DSW2 - primary device for VLAN 103…
Q1. Which technique allows specific VLANs to be strictly permitted by the administrator?A. VTP pruningB. transparent bridgingC. trunk allowed VLANsD. VLAN access-listE. L2P tunnelingView AnswerAnswer: CQ2. What is the maximum number of switches that can be stacked using Cisco StackWise?A. 4B. 5C. 8D. 9E. 10F. 13View AnswerAnswer: DQ3. A network engineer configures port security and 802.1x on the same interface.…
Q1. After reviewing UDLD status on switch ports, an engineer notices that the." Which statement describes what this indicates about the status of the port?A. The port is fully operational and no known issues are detected.B. The bidirectional status of "unknown" indicates that the port will go into the disabled state because it stopped receiving UDLD packets from its neighbor.C.…
Q1. Which statement about restrictions for multichassis LACP is true?A. It is available only on a Cisco Catalyst 6500 Series chassis.B. It does not support 1Gb links.C. Converting a port channel to mLACP can cause a service disruption.D. It is not available in VSS.View AnswerAnswer: CQ2. refer to the exhibit.f1/0 and f1/1 have the same end-to-end path cost to the…
Q1. Which command globally enables AAA on a device?A. aaa new-modelB. aaa authenticationC. aaa authorizationD. aaa accountingView AnswerAnswer: AQ2. Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs. This command is configured globally:monitor session 2 filter vlan 1 - 8, 39, 52What is the result of the implemented command?A. All VLAN traffic is sent to the SPAN…
Q1. what percentage of bandwidth is reduced when a stack cable is broken?A. 0B. 25C. 50D. 75E. 100View AnswerAnswer: CQ2. Refer to the exhibit.Which option describes the reason for this message in a GLBP configuration?A. Unavailable GLBP active forwarderB. Incorrect GLBP IP addressC. HSRP configured on same interface as GLBPD. Layer 2 loopView AnswerAnswer: DQ3. When you configure a private…
Q1. When you configure private VLANs on a switch, which port type connects the switch to the gateway router?A. promiscuousB. communityC. isolatedD. trunkedView AnswerAnswer: AQ2. After reviewing UDLD status on switch ports, an engineer notices that the." Which statement describes what this indicates about the status of the port?A. The port is fully operational and no known issues are detected.B.…
Q1. After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco Discovery Protocol are not visible. Which vendor-neutral protocol could be used to resolve this issue?A. Local Area MobilityB. Link Layer Discovery ProtocolC. NetFlowD. Directed Response ProtocolView AnswerAnswer: BQ2. Refer to the exhibit.The network switches for two…
Q1. refer to the exhibit.f1/0 and f1/1 have the same end-to-end path cost to the designated bridge. Which action is needed to modify the Layer 2 spanning-tree network so that traffic for PC1 VLAN from switch SW3 uses switchport f1/1 as a primary port?A. Modify the spanning-tree port-priority on SW1 f1/1 to 0 and f1/0 to 16.B. Modify the spanning-tree…
Q1. Which First Hop Redundancy Protocol is an IEEE Standard?A. GLBPB. HSRPC. VRRPD. OSPFView AnswerAnswer: CQ2. Which statement about restrictions for multichassis LACP is true?A. It is available only on a Cisco Catalyst 6500 Series chassis.B. It does not support 1Gb links.C. Converting a port channel to mLACP can cause a service disruption.D. It is not available in VSS.View AnswerAnswer:…
Q1. A network engineer wants to ensure Layer 2 isolation of customer traffic using a private VLAN. Which configuration must be made before the private VLAN is configured?A. Disable VTP and manually assign VLANs.B. Ensure all switches are configured as VTP server mode.C. Configure VTP Transparent Mode.D. Enable VTP version 3.View AnswerAnswer: CQ2. A network engineer must improve bandwidth and…
Q1. A network engineer must implement Ethernet links that are capable of transporting frames and IP traffic for different broadcast domains that are mutually isolated. Consider that this is a multivendor environment. Which Cisco IOS switching feature can be used to achieve the task?A. PPP encapsulation with a virtual templateB. Link Aggregation Protocol at the access layerC. dot1q VLAN trunkingD.…
Q1. a network engineer is extending a LAN segment between two geographically separated data centers. Which enhancement to a spanning-tree design prevents unnecessary trafficfrom crossing the extended LAN segment?A. Modify the spanning-tree priorities to dictate the traffic flow.B. Create a Layer 3 transit VLAN to segment the traffic between the sites.C. Use VTP pruning on the trunk interfaces.D. Configure manual…
Q1. To follow the Layer 2 switching guidelines, a network engineer decides to create a separate spanning tree for every group of 10 VLANs. Which version of spanning tree is appropriate to meet the company policy?A. MSTB. PVST+C. RSTPD. RPVST+E. STPView AnswerAnswer: AQ2. Refer to the exhibit.Which statement about switch S1 is true?A. Physical port Fa0/13, Fa0/14, and Fa0/15 successfully…
