Cisco 300-115 Free Practice Questions

Question No: 13

Which two statements apply to topology-based switching?

A. It is functionally equivalent to Cisco Express Forwarding

B. It is the preferred switching mode in Cisco multilayer switches

C. It uses Loop free protocol for switching

D. disabled by default

View Answer

Question No: 14

Refer to the exhibit.

Which EtherChannel negotiation protocol is configured on the interface f0/13 u2013 f0/15?

A. Link Combination Control Protocol

B. Port Aggregation Protocol

C. Port Combination Protocol

D. Link Aggregation Control Protocol

View Answer

Question No: 15

A new network that consists of several switches has been connected together via trunking interfaces. If all switches currently have the default VTP domain name "null", which statement describes what happens when a domain name is configured on one of the switches?

A. The switch with the non-default domain name restores back to "null" upon reboot.

B. Switches with higher revision numbers does not accept the new domain name.

C. VTP summary advertisements are sent out of all ports with the new domain name.

D. All other switches with the default domain name become VTP clients.

View Answer

Question No: 16

The command storm-control broadcast level 75 65 is configured under the switch port connected to the corporate mail server. In which three ways does this command impact the traffic? (Choose three.)

A. SNMP traps are sent by default when broadcast traffic reaches 65% of the lower-level threshold.

B. The switchport is disabled when unicast traffic reaches 75% of the total interface bandwidth.

C. The switch resumes forwarding broadcasts when they are below 65% of bandwidth.

D. Only broadcast traffic is limited by this particular storm control configuration.

E. Multicast traffic is dropped at 65% and broadcast traffic is dropped at 75% of the total interface bandwidth.

F. The switch drops broadcasts when they reach 75% of bandwidth.

View Answer

Question No: 17

Enablement of which feature puts the port into err-disabled state when the port has PortFast enabled and it receives BPDUs?

A. BPDU filtering

B. BackboneFast

C. EtherChannel

D. BPDU guard

View Answer

Question No: 18

What is the default amount by which the hot standby priority for the router is decremented or incremented when the interface goes down or comes back up?

A. 1

B. 5

C. 10

D. 15

View Answer

Question No: 19

Refer to the exhibit.

A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be configured to mirror traffic to a packet sniffer that is connected to the distribution switch? (Choose three.)

A. A monitor session on the distribution switch with a physical interface as the source and the remote SPAN VLAN as the destination

B. A remote SPAN VLAN on the distribution and access layer switch

C. A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destination

D. A monitor session on the distribution switch with a remote SPAN VLAN as the source and physical interface as the destination

E. A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destination

F. A monitor session on the distribution switch with a physical interface as the source and a physical interface as the destination

View Answer

Question No: 20

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.

u2022 DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105

u2022 DSW2 - primary device for VLAN 103 and VLAN 104

u2022 A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.

Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.

During routine maintenance, it became necessary to shut down the GigabitEthernet1/0/1 interface on DSW1 and DSW2. All other interfaces were up. During this time, DSW1 became the active router for the VLAN 104HSRP group. As related to the VLAN 104HSRP group, what can to be done to make the group function properly?

A. On DSW1, disable preempt.

B. On DSW2 decrease the priority value to a value less than 150.

C. On DSW1, increase the decrement value in the track command to a value greater than 6.

D. On DSW1, decrease the decrement value in the track command to a value less than 1.

View Answer

Question No: 21

To provide security, a service provider configures various private VLANs in its backbone network infrastructure to prevent certain VLAN communication to each other. Which version of VTP supports the use of private VLANs?

A. Version 1

B. Version 3

C. VTP does not support private VLANs

D. Version 2

View Answer

Question No: 22

A network engineer is extending a LAN segment between two geographically separated data centers. Which enhancement to a spanning-tree design prevents unnecessary traffic from crossing the extended LAN segment?

A. Modify the spanning-tree priorities to dictate the traffic flow.

B. Create a Layer 3 transit VLAN to segment the traffic between the sites.

C. Use VTP pruning on the trunk interfaces.

D. Configure manual trunk pruning between the two locations.

View Answer

Question No: 23

Which AAA Authorization type includes PPP, SLIP, and ARAP connections?

A. network

B. IP mobile

C. EXEC

D. auth-proxy

View Answer