Cisco 300-175 Free Practice Questions

NEW QUESTION 1
Which policy determines what happens to local disks when they are disassociated from a service profile?

• A. maintenance policy
• B. local disk policy
• C. scrub policy
• D. BIOS policy

Answer: C

NEW QUESTION 2
Which technology makes VM-FEX possible?

• A. VXLAN
• B. VNTAG
• C. VPC
• D. DVS

Answer: B

NEW QUESTION 3
Which two are true with respect to the switching modes on the Cisco Unified Computing System 62XX Fabric Interconnect? (Choose two.)

• A. End-host mode presents a link to a northbound uplink switch as a host trunk with loop detection that is provided by STP.
• B. For northbound traffic, server MAC addresses are statically pinned to an uplink; the return path is controlled by the unified fabric switches.
• C. A fabric interconnect port in Ethernet switching mode appears to the uplink switch as a host with many MAC addresses.
• D. Server-to-server traffic on a common VLAN are locally switched by the fabric interconnect and not the northbound switches.
• E. A MAC forwarding table is not used to forward traffic to the uplink switch.
• F. A MAC address forwarding table is maintained for server-to-server communications across VLANs.

Answer: DE

NEW QUESTION 4
Which two of the following are prerequisites when configuring a server to use SAN boot? (Choose two.)

• A. A virtual media device must be accessible from the server
• B. The global boot policy must be attached to a service profile template.
• C. The local disk must be the primary disk in the boot order.
• D. A boot LUN must contain an installation of an operating system
• E. The Cisco UCS domain and the SAN storage device must be able to communicate

Answer: DE

NEW QUESTION 5
You must upgrade a Cisco UCS -Series Server. Where must the Cisco UCS bundle image be located before you can begin the upgrade?

• A. the Cisco Integrated Management Controller memory of the server
• B. a USB drive connected to a Cisco UCS Fabric Interconnect
• C. a TFTP server accessible to the Cisco UCS Fabric Interconnect
• D. the flash file system of the fabric interconnect

Answer: C

Explanation: Reference:
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/firmware-mgmt/gui/21/b_GUI_Firmware_Man
ger.html#concept_1923688E7A2E46239DCAE363E4A3DE81

NEW QUESTION 6
Which two prerequisites are required to configure a SAN boot from the iSCSI storage of a Cisco UCS system? (Choose two.)

• A. There must be FCIP connectivity between the Cisco UCS domain and the boot target storage.
• B. There must be IP connectivity between the Cisco UCS domain and the boot target storage.
• C. The operating system to boot must be iBFT-capable.
• D. There must be a group of IP addresses that is associated with the WWN pool.
• E. The operating system to boot must be an iSCSI initiator and must he target-capable.

Answer: BC

Explanation: https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/gui/config/guide/2-0/b_UCSM_GUI_Configu

NEW QUESTION 7
Which two Cisco UCS components require drivers? (Choose two.)

• A. FNIC
• B. BIOS
• C. CIMC
• D. board controller
• E. ENIC

Answer: AE

NEW QUESTION 8
You plan to register a Cisco UCS domain to a Cisco UCS Central system UCS Central with determine the policy configuration. Which policy resolution mode must you use when you register the UCS domain?

• A. Global
• B. Private
• C. Local
• D. Central

Answer: A

Explanation: https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/cli/config/guide/2-2/b_UCSM_CLI_Configur

NEW QUESTION 9
You need to implement a Cisco UCS system at a customer Site.
Which adapters and operating systems have preprovisioned adapter policies?

• A. Ethernet vNICs and Windows, OS X Serve
• B. and Oracle Solaris operating systems.
• C. Fibre Channel vNICs and Windows, FreeBSD, and Linux Operating systems.
• D. Ethernet vNICs and Windows, VMware, and Linux operating systems.
• E. Fibre Channel vNICs and Windows, Oracle Solaris, and Linux operating systems.

Answer: D

Explanation: Reference:
http://www.educationalcentre.co.uk/deploy-a-cisco-ucs-system-part-2-from-scratch-for-vmware-esxi/
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/gui/config/guide/2-2/b_UCSM_GUI_Configu

NEW QUESTION 10
You are creating service profiles for a Cisco UCS system by using the service profile wizard. You discover that you forgot to create the UUID pool.
What should you do?

• A. From the wizard, click Create UUID Suffix Pool.
• B. Pause the running wizard, and then start a temporary wizard to create a profile with the same name and the missing UUID poo
• C. Resume the wizard, and then select the new UUID pool.
• D. Continue running the wizar
• E. The service profile uses the burned-in UUID in the BIOS of the server.
• F. Stop the wizard, and then restart the wizard.

Answer: A

Explanation: Step 4
(Optional) If you want to create a new UUID Suffix pool to use in this service profile, click Create UUID Suffix
Pool and complete the fields in the Create UUID Suffix Pool wizard. For more information, see Creating a UUID Suffix Pool.
Reference:
https://www.cisco.com/en/US/docs/unified_computing/ucs/sw/gui/config/guide/141/ UCSM_GUI_Configuration_Guide_141_chapter24.html

NEW QUESTION 11
Refer to the exhibit.

Which description of the result is true?

• A. An Ethernet monitoring session was created where traffic may be copied and forwarded to slot 1 port 9 for analysis.
• B. An Ethernet monitoring session was created, activated and committed.
• C. Ethernet traffic from slot 9 port 1 will be copied and forwarded to the destination SPAN port for analysis.
• D. Ethernet traffic from slot 1 port 9 will be copied and forwarded to the destination SPAN port for analysis.

Answer: A

NEW QUESTION 12
Refer to the exhibit.

Which two action do you perform on the remote switch before you run the commands? 9Choose two)

• A. Configure a minimum of eight links in the port channel.
• B. Configure the remote switch to use NPIV mode.
• C. Set port channel mode to on.
• D. Configure the remote switch for NPV.
• E. Enable the port-channel-trunk feature.

Answer: BC

NEW QUESTION 13
Which two tasks enable jumbo frames on a Cisco UCS system? (Choose two.)

• A. In the LAN cloud on Cisco UCS Manager, configure MTU 9000 in the uplink interfaces.
• B. In the LAN cloud on Cisco UCS Manager, enable jumbo frames in Fabric A and Fabric B.
• C. In the LAN cloud on Cisco UCS Manager, configure MTU 9000 in the VLAN.
• D. In the LAN cloud on Cisco UCS Manager, define a QoS system class with MTU 9000.
• E. In the service profile, configure MTU 9000 in the vNIC.
• F. In the service profile, configure MTU 9000 in the virtual machine.
• G. In the service profile, configure MTU 9000 in the uplink interfaces.

Answer: DE

NEW QUESTION 14
You need to automate the management of servers, networks, and storage on a Cisco UCS system, by using PowerShell.
Which tool should you use?

• A. Cisco UCS Platform Emulator
• B. Cisco UCS Python SDK
• C. Cisco UCS Automation Tool
• D. Cisco UCS PowerTool Suite

Answer: D

Explanation: Reference:
http://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/microsoft-applications-on-ucs/broch

NEW QUESTION 15
The system-reserved VLANs within Cisco UCS are 3968 to 4048 by default. Where can a user change the starting value of this range?

• A. VLAN manager
• B. global policies
• C. LAN cloud
• D. cannot be changed

Answer: D

NEW QUESTION 16
Which option describes the Network Security feature of Cisco intergrated Management Controller?

• A. User-configured ACLs that deny devices access to the Cisco IMC.
• B. 802.1x support which permits the Cisco IMC access to the port security network.
• C. A feature that locks users out of the Cisco IMC after a specified number of unsuccessful log in attempts.
• D. A list that specifies the devices allowed to access the Cisco IMC.

Answer: C

NEW QUESTION 17
Which two descriptions of the Call Home feature on a Cisco UCS server are true? (Choose two.)

• A. Uses Java to generate predefined reports
• B. Provides an email-based notification for critical system policies
• C. Provides all the information to administrators, who can open a case with one click
• D. Delivers alerts to multiple recipients, including Cisco TAC, and generates a case by using Cisco TAC
• E. Provides a central repository for storing fault data

Answer: BD

Explanation: Reference:
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/gui/config/guide/1-31/b_UCSM_GUI_Configu

NEW QUESTION 18
With Cisco UCS Manager, in which location do you monitor the chassis discovery process?

• A. CMC
• B. FSM
• C. CDP
• D. DME

Answer: B

Explanation: Reference:
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/gui/config/guide/20/b_UCSM_GUI_Configura

NEW QUESTION 19
Which two are true concerning the role-based access control specifics of a Cisco Unified Computing System? (Choose two.)

• A. Disabled local user accounts are deleted from the database.
• B. A locally authenticated user account is any user account that is authenticated through LDAP, RADIUS, or TACACS+.
• C. If a user maintains a local user account and a remote user account simultaneously, the roles that are defined in the local user account override those that are maintained in the remote user account.
• D. By default, user accounts expire after 90 days; a warning message will be generated 10 days prior to expiration.
• E. A user that is assigned one or more roles will be allowed the privileges that are consistent across all of the assigned roles.
• F. All roles include read access to all configuration settings in the Cisco Unified Computing System domain.

Answer: CF