300-209 Premium Bundle

300-209 Premium Bundle

Implementing Cisco Secure Mobility Solutions (SIMOS) Certification Exam

4.5 
(9315 ratings)
0 QuestionsPractice Tests
0 PDFPrint version
November 21, 2024Last update

Cisco 300-209 Free Practice Questions

Q1. Which two examples of transform sets are contained in the IKEv2 default proposal? (Choose two.) 

A. aes-cbc-192, sha256, 14 

B. 3des, md5, 5 

C. 3des, sha1, 1 

D. aes-cbc-128, sha, 5 

Answer: B,D 

Q2. A spoke has two Internet connections for failover. How can you achieve optimum failover without affecting any other router in the DMVPN cloud? 

A. Create another DMVPN cloud by configuring another tunnel interface that is sourced from the second ISP link. 

B. Use another router at the spoke site, because two ISP connections on the same router for the same hub is not allowed. 

C. Configure SLA tracking, and when the primary interface goes down, manually change the tunnel source of the tunnel interface. 

D. Create another tunnel interface with same configuration except the tunnel source, and configure the if-state nhrp and backup interface commands on the primary tunnel interface. 

Answer:

Q3. Refer to the exhibit. 

A customer cannot establish an IKEv2 site-to-site VPN tunnel between two Cisco ASA devices. Based on the syslog message, which action can bring up the VPN tunnel? 

A. Increase the maximum SA limit on the local Cisco ASA. 

B. Correct the crypto access list on both Cisco ASA devices. 

C. Remove the maximum SA limit on the remote Cisco ASA. 

D. Reduce the maximum SA limit on the local Cisco ASA. 

E. Correct the IP address in the local and remote crypto maps. 

F. Increase the maximum SA limit on the remote Cisco ASA. 

Answer:

Q4. Which application does the Application Access feature of Clientless VPN support? 

A. TFTP 

B. VoIP 

C. Telnet 

D. active FTP 

Answer:

Q5. Which adaptive security appliance command can be used to see a generic framework of the requirements for configuring a VPN tunnel between an adaptive security appliance and 

a Cisco IOS router at a remote office? 

A. vpnsetup site-to-site steps 

B. show running-config crypto 

C. show vpn-sessiondb l2l 

D. vpnsetup ssl-remote-access steps 

Answer:

Q6. Which technology supports tunnel interfaces while remaining compatible with legacy VPN implementations? 

A. FlexVPN 

B. DMVPN 

C. GET VPN 

D. SSL VPN 

Answer:

Q7. A user is trying to connect to a Cisco IOS device using clientless SSL VPN and cannot establish the connection. Which three commands can be used for troubleshooting of the AAA subsystem? (Choose three.) 

A. debug aaa authentication 

B. debug radius 

C. debug vpn authorization error 

D. debug ssl openssl errors 

E. debug webvpn aaa 

F. debug ssl error 

Answer: A,B,D 

Q8. Scenario: 

You are the senior network security administrator for your organization. Recently and junior engineer configured a site-to-site IPsec VPN connection between your headquarters Cisco ASA and a remote branch office. 

You are now tasked with verifying the IKEvl IPsec installation to ensure it was properly configured according to designated parameters. Using the CLI on both the Cisco ASA and branch ISR, verify the IPsec configuration is properly configured between the two sites. 

NOTE: the show running-config command cannot be used for this exercise. 

Topology: 

at is being used as the authentication method on the branch ISR? 

A. Certifcates 

B. Pre-shared keys 

C. RSA public keys 

D. Diffie-Hellman Group 2 

Answer:

Explanation: 

The show crypto isakmp key command shows the preshared key of “cisco”. 

Q9. When you troubleshoot Cisco AnyConnect, which step does Cisco recommend before you open a TAC case? 

A. Show applet Lifecycle exceptions. 

B. Disable cookies. 

C. Enable the WebVPN cache. 

D. Collect a DART bundle. 

Answer:

Q10. Which technology can rate-limit the number of tunnels on a DMVPN hub when system utilization is above a specified percentage? 

A. NHRP Event Publisher 

B. interface state control 

C. CAC 

D. NHRP Authentication 

E. ip nhrp connect 

Answer:

Q11. Which technology can provide high availability for an SSL VPN? 

A. DMVPN 

B. a multiple-tunnel configuration 

C. a Cisco ASA pair in active/passive failover configuration 

D. certificate to tunnel group maps 

Answer:

Q12. Refer to the exhibit. 

You have implemented an SSL VPN as shown. Which type of communication takes place between the secure gateway R1 and the Cisco Secure ACS? 

A. HTTP proxy 

B. AAA 

C. policy 

D. port forwarding 

Answer:

Q13. You are troubleshooting a DMVPN NHRP registration failure. Which command can you use to view request counters? 

A. show ip nhrp nhs detail 

B. show ip nhrp tunnel 

C. show ip nhrp incomplete 

D. show ip nhrp incomplete tunnel tunnel_interface_number 

Answer:

Q14. In the Diffie-Hellman protocol, which type of key is the shared secret? 

A. a symmetric key 

B. an asymmetric key 

C. a decryption key 

D. an encryption key 

Answer:

Q15. An administrator desires that when work laptops are not connected to the corporate network, they should automatically initiate an AnyConnect VPN tunnel back to headquarters. Where does the administrator configure this? 

A. Via the svc trusted-network command under the group-policy sub-configuration mode on the ASA 

B. Under the "Automatic VPN Policy" section inside the Anyconnect Profile Editor within ASDM 

C. Under the TNDPolicy XML section within the Local Preferences file on the client computer 

D. Via the svc trusted-network command under the global webvpn sub-configuration mode on the ASA 

Answer:

START 300-209 EXAM