Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. What are two characteristics of Cisco Global Site Selector? (Choose two.)
A. It helps verify end-to-end path availability.
B. It provides traffic rerouting in case of disaster.
C. HSRP, GLBP, and VRRP can be clients of GSS.
D. BGP must be the routing protocol between the distributed data centers.
E. DNS responsiveness is improved by providing centralized domain management.
Answer: B,E
Q2. Which option describes why duplicate IP addresses reside on the same network in Cisco network design?
A. HSRP designed network
B. using Cisco ACE in active/passive mode
C. VRRP designed network
D. running multiple routing protocols
Answer: B
Q3. Which three of these Metro service types map to E-Line (versus E-LAN) services that are defined by the Metro Ethernet Forum (MEF)? (Choose three.)
A. Ethernet Private Line
B. Ethernet Wire Service
C. Ethernet Relay Service
D. Ethernet Multipoint Service
E. Ethernet Relay Multipoint Service
Answer: A,B,C
Q4. DRAG DROP
Answer:
Q5. Which two physical components can enable high availability on a Cisco 6500 device? (Choose two.)
A. dual supervisor modules
B. bundled Ethernet Interconnects
C. line modules with DFCs
D. redundant power supplies
E. VSS interlink cables
Answer: A,D
Q6. A network engineer must provide 40mb connections from the data center to the corporate office and two remote offices. What WAN connectivity option will outsource the routing in cooperation with the service provider?
A. Ethernet Private Line
B. Ethernet Multipoint Service
C. MPLS VPN
D. VPLS
Answer: C
Q7. What are the three configuration requirements for implementing Modular QoS on a router? (Choose three.)
A. CoS
B. class map
C. precedence
D. service policy
E. priority
F. policy map
Answer: B,D,F
Q8. A network engineer must create a Layer 2 switch block design that has deterministic convergence and is loop-free at Layer 2. Which two switch block elements are needed to meet the requirements? (Choose two.)
A. Layer 3 link between distribution switches
B. HSRP with interface tracking on uplinks to core switches
C. RPVST with equal bridge priority on distribution switches
D. VLANs that do not span access switches
E. Layer 2 link between distribution switches
Answer: A,D
Q9. Which IPv4 multicast technical component measure provides architectural security?
A. IGMP max groups
B. access lists
C. scoped addresses
D. state limit
Answer: C
Q10. A company requires redundancy for its multihomed BGP external connections. What two features can be configured on the WAN routers to automate failover for both outbound and inbound traffic? (Choose two.)
A. AS path prepending
B. local preference
C. floating static route
D. HSRP
E. MED
F. weight
Answer: A,D
Q11. Which of the following facts must be considered when designing for IP telephony within an Enterprise Campus network?
A. Because the IP phone is a three-port switch, IP telephony extends the network edge, impacting the Distribution layer.
B. Video and voice are alike in being bursty and bandwidth intensive, and thus impose requirements to be lossless, and have minimized delay and jitter.
C. IP phones have no voice and data VLAN separation, so security policies must be based on upper layer traffic characteristics.
D. Though multi-VLAN access ports are set to dot1q and carry more than two VLANs they are not trunk ports.
Answer: D
Q12. In base e-Commerce module designs, where should firewall perimeters be placed?
A. core layer
B. Internet boundary
C. aggregation layer
D. aggregation and core layers
E. access and aggregation layers
Answer: A
Q13. Which of these is a recommended practice with trunks?
A. use ISL encapsulation
B. use 802.1q encapsulation
C. set ISL to desirable and auto with encapsulation negotiate to support ILS protocol negotiation
D. use VTP server mode to support dynamic propagation of VLAN information across the network
Answer: B
Q14. A network design engineer has been asked to reduce the size of the SPT on an IS-IS broadcast network. Which option should the engineer recommend to accomplish this task?
A. Configure the links as point-to-multipoint.
B. Configure QoS in all links.
C. Configure a new NET address.
D. Configure the links as point-to-point.
Answer: D
Q15. Which three statements about Network Attached Storage are correct? (Choose three.)
A. Data is accessed using NFS or CIFS.
B. Data is accessed at the block level.
C. NAS is referred to as captive storage.
D. Storage devices can be shared between servers.
E. A NAS implementation is not as fast as a DAS implementation.
Answer: A,D,E