Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. DRAG DROP
Answer:
Q2. A network engineer wants to connect two sites via a WAN technology and to securely pass multicast traffic over this WAN technology. Which WAN technology should be configured?
A. IPsec
B. GRE
C. pure MPLS
D. GRE over IPsec
Answer: D
Q3. Which statement about Fibre Channel communications is correct?
A. N_Port to N_Port connections use logical node connection points.
B. Flow control is only provided by QoS.
C. It must be implemented in an arbitrated loop.
D. Communication methods are similar to those of an Ethernet bus.
Answer: A
Q4. A campus network in a switch block design requires redundant distribution switches, load sharing across uplinks, a loop-free topology, and only one gateway IP address per VLAN. Which switching technology meets all of the requirements?
A. HSRP
B. VSS
C. Spanning Tree Protocol
D. EtherChannel
Answer: B
Q5. To which network layer should Cisco Express Forwarding be tuned to support load balancing and to make more informed forwarding decisions?
A. Layer 1
B. Layer 2
C. Layer 3
D. Layer 4
E. Layer 5
F. Layer 6
G. Layer 7
Answer: D
Q6. Which feature set enables the full OSPF routing process when using a Cisco Catalyst 3750X Switch?
A. LAN base
B. IP base
C. IP services
D. enterprise access
Answer: C
Q7. When an enterprise network is designed, which protocol provides redundancy for edge devices in the event of a first-hop failure?
A. ICMP
B. HSRP
C. STP
D. HTTP
Answer: B
Q8. Which architecture provides a way to deliver end-to-end QoS as required by real-time voice and video business applications?
A. IntServ
B. DiffServ
C. LLQ
D. ToS
E. DSCP
Answer: A
Q9. Which command can you enter to inject BGP routes into an IGP?
A. redistribute bgp
B. redistribute static
C. redistribute static subnet
D. default-information originate
Answer: A
Q10. When a router has to make a rate transition from LAN to WAN, what type of congestion needs should be considered in the network design?
A. RX-queue deferred
B. TX-queue deferred
C. RX-queue saturation
D. TX-queue saturation
E. RX-queue starvation
F. TX-queue starvation
Answer: F
Q11. Which two WAN technologies support IEEE 802.1Q, site-to-site connectivity, and point-to-point connectivity between two offices? (Choose two.)
A. Ethernet over MPLS
B. VPLS
C. Layer 3 MPLS
D. DSL
E. cable
Answer: A,B
Q12. The requirement for high availability within the Data Center network may cause the designer to consider which one of the following solutions?
A. Construct a hierarchical network design using EtherChannel between a server and two VDCs from the same physical switch
B. Utilize Cisco NSF with SSO to provide intrachassis SSO at Layers 2 to 4
C. Define the Data Center as an OSPF NSSA area, advertising a default route into the DC and summarizing the routes out of the NSSA to the Campus Core
D. Implement network services for the Data Center as a separate services layer using an active/active model that is more predictable in failure conditions
Answer: B
Q13. Which option is a common cause of congestion found in a campus network?
A. input serialization delay
B. output serialization delay
C. Rx-queue starvation
D. Tx-queue starvation
Answer: D
Q14. Which type of connectivity is required for VPLS?
A. full mesh
B. partial mesh
C. star
D. bus
E. ring
Answer: A
Q15. Which statement about IPS and IDS solutions is true?
A. IDS and IPS read traffic only in inline mode.
B. IDS and IPS read traffic only in promiscuous mode.
C. An IDS reads traffic in inline mode, and an IPS reads traffic in promiscuous mode.
D. An IDS reads traffic in promiscuous mode, and an IPS reads traffic in inline mode.
Answer: D