Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. A company uses BGP to connect with the ISP on the enterprise network and wants to improve performance due to the increasing number of iBGP peers. Which two design solutions address the iBGP full mesh requirement? (Choose two.)
A. route reflectors
B. confederations
C. AS path prepending
D. communities
E. conditional advertising
Answer: A,B
Q2. What Nexus technology avoids blocking links between the access layer and the aggregation layer in a data center network design?
A. FCoE
B. LACP
C. vPC
D. FEX
Answer: C
Q3. Which two network management capabilities that are embedded in Cisco IOS Software will baseline existing application traffic? (Choose two.)
A. Syslog
B. AutoQoS
C. NetFlow
D. SNMP
E. NBAR
F. Logging
Answer: C,E
Q4. AutoQoS is used to implement VoIP in the enterprise, but the trust option is not configured on the interface. Which network management Cisco IOS capability classifies the voice traffic?
A. NetFlow
B. SNMP
C. IP SLAs
D. NBAR
Answer: D
Q5. Which feature supports multiple routing tables with overlapping networks on a single device?
A. VRF
B. Metro Ethernet
C. RSTP
D. VSS
Answer: A
Q6. What is one reason to implement Control Plane Policing?
A. allow OSPF routing protocol to advertise routes
B. protect the network device route processor from getting overloaded by rate limiting the incoming control plane packets
C. allow network devices to generate and receive packets
D. protect the data plane packets
Answer: B
Q7. Which option provides software modularity in Cisco NX-OS software in the data center design?
A. The ip routing command enables all of the features in the Cisco NX-OS.
B. All of the features are enabled by default in the Cisco NX-OS.
C. Individual features must be manually enabled to start the process.
D. The Cisco NX-OS has a management VRF that is enabled by default.
Answer: C
Q8. What are three primary components in IS-IS fast convergence? (Choose three.)
A. event propagation
B. LSP flooding
C. fast hellos
D. matching MTUs
E. updating RIB and FIB
F. SPF calculation
Answer: A,E,F
Q9. A designer should have which three technologies in the network before configuring MPLS Layer 3 VPNs? (Choose three.)
A. MPLS
B. LDP
C. Cisco Express Forwarding
D. VSS
E. vPC
F. VRRP
Answer: A,B,C
Q10. Source traffic is sent to a VIP on an SLB device, which in turn is routed to the destination server. Return traffic is policy-based routed back to the SLB.
Which SLB design has been implemented?
A. router mode
B. inline bridge mode
C. one-armed mode
D. two-armed mode
Answer: D
Q11. Which multicast address must be available for FHRP advertisements in a multivendor environment?
A. 224.0.0.9
B. 224.0.0.18
C. 224.0.0.102
D. 224.0.0.2
Answer: B
Q12. From a design perspective which two of the following OSPF statements are most relevant? (Choose two)
A. OSPF stub areas can be thought of as a simple form of summarization
B. OSPF cannot filter intra-area routes
C. An ABR can only exist in two areas - the backbone and one adjacent area
D. Performance issues in the Backbone area can be offset by allowing some traffic to transit a non-backbone area
E. The size of an area (the LSDB) will be constrained by the size of the IP MTU
Answer: A,B
Q13. Which four options are network virtualization technologies that are employed in the data center? (Choose four.)
A. VLAN
B. VSAN
C. VRF
D. VRP
E. VLC
F. VPC
Answer: A,B,C,F
Q14. ACME corporation owns a single MDS.
Which two SAN tools can be used to optimize the use and cost of the switching hardware? (Choose two.)
A. zoning
B. IVR
C. VSAN
D. iSCSI
Answer: A,C
Q15. Which two ways to support secure transport of multicast traffic are true? (Choose two.)
A. Use spoke-to-spoke design.
B. Use IPsec over GRE tunnel.
C. Use GET VPN.
D. Use NBMA instead of broadcast.
E. Disable encryption for multicast traffic.
Answer: B,C