Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. A company implemented VoIP in a campus network and now wants a consistent method to implement using AutoQoS. Which two parameters must be considered before AutoQoS is configured? (Choose two.)
A. CEF must be enabled.
B. AutoQoS is available only on routers.
C. Traffic discovery must be performed manually.
D. No service policy can be applied already.
E. Manual traffic analysis must be performed.
Answer: A,D
Q2. What two sensor types exist in an IDS/IPS solution? (Choose two.)
A. host
B. anomaly based
C. policy based
D. network based
E. signature
Answer: A,D
Q3. Which statement is the most accurate regarding IPsec VPN design for an Enterprise Campus environment?
A. VPN device IP addressing must align with the existing Campus addressing scheme.
B. The choice of a hub-and-spoke or meshed topology ultimately depends on the number of remotes.
C. Sizing and selection of the IPsec VPN headend devices is most affected by the throughput bandwidth requirements for the remote offices and home worker
D. Scaling considerations such as headend configuration, routing protocol choice, and topology have the broadest impact on the design.
Answer: D
Q4. Which technology allows network managers to centrally manage the VLAN database?
A. VTP
B. VLAN
C. VSS
D. vPC
Answer: A
Q5. A network team must provide a redundant secure connection between two entities using OSPF. The primary connection will be an Ethernet Private Line and the secondary connection will be a site-to-site VPN. What needs to be configured in order to support routing requirements for over the VPN connection?
A. GRE Tunnel
B. HTTPS
C. Root Certificate
D. AAA Server
Answer: A
Q6. In a collapsed core design, which three benefits are provided by a second-generation Cisco MDS director? (Choose three.)
A. a higher fan-out ratio
B. fully redundant switches
C. 100 percent port efficiency
D. all ISLs contained within a single chassis
E. higher latency and throughput than a core-edge design switch
Answer: B,C,D
Q7. When is a first-hop redundancy protocol needed in the distribution layer?
A. when the design implements Layer 2 between the access and distribution blocks
B. when multiple vendor devices need to be supported
C. when preempt tuning of the default gateway is needed
D. when a robust method of backing up the default gateway is needed
E. when the design implements Layer 2 between the access switch and the distribution blocks
Answer: A
Q8. Support of vPC on the Cisco Nexus 5000 access switch enables various new design options for the data center Access layer, including which of the following?
A. The vPC peer link is not required for Access layer control traffic, and can instead be used to span VLANs across the vPC access switches
B. A single switch can associate per-interface with more than one vPC domain
C. vPC can be used on both sides of the MEC, allowing a unique 16-link EtherChannel to be built between the access and aggregation switches
D. Allows an EtherChannel between a server and a access switch while still maintaining the level of availability that is associated with dual-homing a server to two different access switches
Answer: C
Q9. Which of the following is a recommended practice of a data center core?
A. Server-to-server traffic always remains in the core layer.
B. The core infrastructure should be in Layer 3.
C. Core layer should run BGP along with an IGP because iBGP has a lower administrative distance than any IGP.
D. The Cisco Express Forwarding hashing algorithm is the default, based on the IP address and Layer 4 port.
Answer: B
Q10. To which network layer should Cisco Express Forwarding be tuned to support load balancing and to make more informed forwarding decisions?
A. Layer 1
B. Layer 2
C. Layer 3
D. Layer 4
E. Layer 5
F. Layer 6
G. Layer 7
Answer: D
Q11. To support the enterprise high-availability requirements, which workgroup switch technology can be used to interconnect multiple switches into a single logical unit?
A. StackWise
B. EtherChannel
C. VSS
D. vPC
E. Flex Links
Answer: A
Q12. Two recently merged companies are using EIGRP and RIP. Which two strategies can facilitate a smooth migration? (Choose two.)
A. Create an OSPF instance between EIGRP and RIP routing domains.
B. Redistribute routing information between the RIP and EIGRP protocols.
C. Add EIGRP and then remove RIP on the acquired company network.
D. Use the EIGRP administrative distance to migrate one site at a time.
E. Use static routes in place of dynamic routing between companies.
Answer: B,C
Q13. When a router has to make a rate transition from LAN to WAN, what type of congestion needs should be considered in the network design?
A. RX-queue deferred
B. TX-queue deferred
C. RX-queue saturation
D. TX-queue saturation
E. RX-queue starvation
F. TX-queue starvation
Answer: F
Q14. A network engineer is designing a network that must incorporate seamless failover when a link failure occurs between the core and distribution layer. What two technologies will allow this? (Choose two.)
A. ECMP
B. RSTP
C. MEC
D. GLBP
E. HSRP
Answer: A,C
Q15. Which feature must be configured for the VRRP-enabled router to regain the master VRRP status upon recovery from a failure?
A. priority
B. authentication
C. pre-emption
D. Stateful Switchover
Answer: C