Cisco 350-801 Free Practice Questions

NEW QUESTION 1
On which Cisco Unified Communications Manager nodes can the TFTP service be enabled?

• A. any node
• B. any two nodes
• C. only nodes that have Cisco Unified CM service enabled
• D. any subscriber nodes

Answer: C

Explanation:
You can configure the TFTP service on the first node or a subsequent node, but usually you should configure it on the first node. For small systems, the TFTP server can coexist with a Cisco Unified Communications Manager on the same server.

NEW QUESTION 2
Refer to the exhibit.

This INVITE is sent to an endpoint that only supports G729. What must be done for this call to succeed?

• A. Nothing: both sides support G.729.
• B. Add a transcoder that supports G711ulaw and G.729.
• C. Add a media termination point that supports G.711ulaw and G.729.
• D. Nothing: both sides support payload type 101.

Answer: D

NEW QUESTION 3
Refer to the exhibit.

Given this "debug isdn q921" output, what is the problem with the PRI?

• A. Layer 1 is down on the controller.
• B. PRI does not have an IP address configured on the interface.
• C. Nothing, the PRI is sending keepalives.
• D. Layer 2 is down on the controller.

Answer: D

NEW QUESTION 4
Which method is used to avoid toll fraud with Cisco Unified Communications Manager calls?

• A. call policy service
• B. TOLLFRAUD_APP
• C. default zone access rules
• D. class of service

Answer: D

NEW QUESTION 5
Which command is used in Cisco IOS XE TDM gateway to configure the voice T1/E1 controller to provide clocking?

• A. clock source line
• B. Cisco IOS XE TDM gateway T1/E1 controller cannot provide clocking.
• C. clocking source internal
• D. clocking source network

Answer: C

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/NIM/software/configuration/guide/4gen-t1-e1-nim-guide.html

NEW QUESTION 6
You are adding regions in Cisco Unified Communications Manager. Which codec(s) are selected when a call is placed if you set up the max audio bit rate to use 8 kbps?

• A. G.729
• B. G 729 and G.711ulaw
• C. G.711ulaw and G 711alaw
• D. G.722

Answer: A

NEW QUESTION 7
An engineer must configure an MGCP gateway and register it to Cisco Unified Communications Manager. Which prerequisite must be met before applying the gateway commands to enable MGCP?

• A. The MGCP gateway and the Cisco Unified CM must be able to communicate aver ports 5060 and 5061.
• B. Cisco Unified CM and the MGCP gateway must utilize the SIP OPTIONS ping feature to monitor status.
• C. The MGCP gateway must have voice service VoIP configured.
• D. The MGCP gateway and the Cisco Unified CM must be able to communicate over ports 2427, 2428, and 2727.

Answer: D

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/ios/voice/cminterop/configuration/guide/12_4t/vc_12_4t_book/vc_ucm_mgcp_gw.html

NEW QUESTION 8
Which description of the Mobile and Remote Access feature is true?

• A. Collaboration Edge feature that enables remote individuals to perform international calls from Jabber with a VPN connection.
• B. Collaboration Edge feature that enables remote individuals to access all enterprise collaboration services using a PC within the corporate environment.
• C. Collaboration Edge feature that enables remote individuals to access enterprise collaboration services via Jabber without the use of a VPN connection.
• D. Collaboration Edge feature that enables remote individuals to access enterprise collaboration services via Jabber with the use of a VPN connection.

Answer: C

NEW QUESTION 9
Which action prevents toll fraud in Cisco Unified Communications Manager?

• A. Implement toll fraud restriction in the Cisco IOS router.
• B. Implement route patterns in Cisco Unified CM.
• C. Allow off-net to off-net transfers.
• D. Configure ad hoc conference restriction.

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-express/107626-cme-toll-fraud.html

NEW QUESTION 10
When a phone is registered over Mobile and Remote Access, where does it register?

• A. Cisco Unified Presence Server
• B. Expressway-E
• C. Cisco Unified Communications Manager
• D. Expressway-C

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_01011010.html QUESTION

NEW QUESTION 11
Refer to the exhibit.

You deploy Mobile and Remote Access for Jabber and discover that Jabber for Windows does no register to Cisco Unified Communication Manager while outside of the office. What is a cause of this issue?

• A. Server 4.2.2.2 is not a valid DNS server.
• B. The DNS record should be created for _cisco-uds._tcp.example.com.
• C. The DNS record should be changed from _collab-edge._tcp.example.com to _collab-edge _tls.example.com.
• D. The DNS record type should be changed from SRV to A.

Answer: C

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/jabber/Windows/9_7/CJAB_BK_C606D8A9_00_cisco-jabber-dns-configuration-guide/CJAB_BK_C606D8A9_00_cisco-jabber-dns-configuration-guide_chapter_010.html

NEW QUESTION 12
Which two types of device are supported by the Bulk Administration Tool? (Choose two.)

• A. H.322 clients
• B. Cisco Unified IP phones (all models)
• C. SIP trunks
• D. H.225 trunks
• E. music on hold servers

Answer: AB

NEW QUESTION 13
How can an engineer determine location-based CAC bandwidth requirements for Cisco Unified Communications Manager?

• A. Set the requirements in the service parameters.
• B. Add the requirements for each audio and video codec and how many calls must be supported.
• C. Execute the Resource Reservation Protocol to return location-based requirements.
• D. Calculate the number of calls against the license for Cisco Unified Border Element to determine calls per location.

Answer: A

NEW QUESTION 14
Refer to the exhibit.

A call is failing to establish between two SIP Devices The called device answers with this SOP. Which SDP parameter causes this issue?

• A. The payload for G.711ulaw must be 18.
• B. The calling device did not offer a ptime value.
• C. The media stream is set to sendonly.
• D. The RTP port is set to 0.

Answer: D

NEW QUESTION 15
Which issue causes slips on a PRI?

• A. incorrect clock source
• B. incorrect encapsulation
• C. incorrectly configured time zone
• D. change in the line code

Answer: A

NEW QUESTION 16
What is a characteristic of video traffic that governs QoS requirements for video?

• A. Video is typically variable bit rate.
• B. Voice and video traffic are different, but they have the same QoS requirements.
• C. Video is typically constant bit rate.
• D. Voice and video traffic are the same, so they have the same QoS requirements.

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab11/collab11/cac.html

NEW QUESTION 17
Refer to the exhibit.

An engineer configures a VoIP dial peer on a Cisco gateway. Which codec is used?

• A. G.711ulaw
• B. No codec is used (missing codec command).
• C. G.711alaw
• D. G.729r8

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/dialpeer/configuration/15-mt/vd-15-mt-book/vd-dp-cfg-examp.pdf

NEW QUESTION 18
An engineer configures local route group to simplify a dial plan. Where does the engineer set the route groups according to the local route group names that are configured?

• A. CSS
• B. route pattern
• C. device pool
• D. route list

Answer: D

NEW QUESTION 19
Where is the default for Maximum Session Bit Rate for a region configured?

• A. Service Parameter Configuration
• B. Enterprise Phone Configuration
• C. Enterprise Parameters Configuration
• D. Region Configuration

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/9_1_1/ccmcfg/CUCM_BK_A34970C5_00_admin-guide-91/CUCM_BK_A34970C5_00_admin-guide-91_chapter_0111.html

NEW QUESTION 20
An engineer is notified that the Cisco TelePresence MX800 that is registered in Cisco Unified Communications Manager shows an empty panel, and the Touch 10 shows a corresponding icon with no action when pressed. Where does the engineer go to remove the inactive custom panel?

• A. The Software Upgrades page in CUCM OS Administration
• B. The In-Room Control Editor on the webpage of the MX800
• C. The phone configuration page in CUCM Administration
• D. The SIP Trunk Security Profile page in CUCM Administration

Answer: A

NEW QUESTION 21
An administrator recently upgraded a Cisco Webex DX80 through its web interface but discovered the next morning that the unit has received to its previous version. What must the administrator do to prevent this from happening again?

• A. Assign a phone security profile with secure SIP.
• B. Set the prepare cluster for rollback to pre-8-0 enterprise parameter to true.
• C. Confirm the phone load name in the phone configuration.
• D. Assign a universal device template to the phone.

Answer: C

NEW QUESTION 22
What field is configured to change the caller ID information on a SIP route pattern?

• A. Route Partition
• B. Called Party Transformation Mask
• C. Calling Party Transformation Mask
• D. Connected Line ID Presentation

Answer: D

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmcfg/CUCM_BK_C95ABA82_00_admin-guide-100/CUCM_BK_C95ABA82_00_admin-guide-100_chapter_0100111.pdf

NEW QUESTION 23
......