Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
P.S. Top Quality 400-101 guidance are available on Google Drive, GET MORE: https://drive.google.com/open?id=1cF02oX7GSasuEXS-dBzgjdZ6VV4eo-Md
New Questions 7
Which two improvements do SIA-Query and SIA-Reply messages add to EIGRP? {Choose two)
A. Stuck-in-active conditions are solves faster.
B. They prevent a route from going into the stuck-in-active state.
C. They help in the localization of the real failure in the network.
D. The EIGRP adjacency between two neighbors never goes down.
Answer: A,C
New Questions 8
Which two message types allow PIM snooping to forward multicast traffic? (Choose two)
A. membership query messages
B. leave messages
C. bidirectional PIM DF election messages
D. Hello messages
Answer: C,D
New Questions 9
How can you reduce latency on a VoIP network?
A. Set the IP SLA timeout to 1000 milliseconds
B. Implement fast retransmission
C. Configure an SLA to collect information on packet loss
D. Implement low-latency queuing
E. Implement a congestion-avoidance algorithm
Answer: D
New Questions 10
What is the default 1S-1S interface metric on a Cisco router?
A. 128
B. 64
C. 10
D. 255
Answer: C
New Questions 11
Refer to the exhibit When traffic marked as CoS 5 arrives on the switch.what DSCP value does the switch apply?
A. 0
B. 32
C. 40
D. 46
E. 48
Answer: B
New Questions 12
Which statement about the RPF interface in a BIDIR-PIM network is true?
A. In a BIDIR-PIM network the RPF interface can be the interface that is used reach the PIM rendezvous or the interface that is used to reach the source.
B. In a BIDIR-PIM network the RPF interface is always the interface that is used to reach the source.
C. There is no RPF interface concept in BIDIR-PIM networks
D. In a BIDIR network the RPF interface is always the interface that is used to reach the PIM rendezvous point.
Answer: D
New Questions 13
If you configure a router interface for both IPv4 and IPv6 on an IS-IS network in single- topology mode.what additional configuration is required?
A. IPv4 and IPv6 must be configured on different routing protocols
B. IPv4 and IPv6 must be configured to run the same IS-IS level.
C. IPv4 and IPv6 must be configured with different metric types
D. IPv4 and IPv6 addresses must be configured with the same prefix length
Answer: B
New Questions 14
Which two options are types of EVCs?(Choose two)
A. GRE
B. NSSA
C. E-line
D. E-LAN
E. NMBA
Answer: C,D
New Questions 15
Refer to the exhibit. R1 and R2 have been configured as BGP neighbors, but their session is stuck in active. Which action can you take that will enable a session to beestablished?
A. Enable synchronization on R1 R2
B. Issue the neighbor 10.1.12 .2 activate command on R'1
C. Configure 10.1.12.1 as the BGP router 10 on R1
D. Configure a neighbor relation ship with the Loopback0 address of R1 on R2
Answer: D
New Questions 16
Refer to the exhibit.
Switch A is connected to two MST domains for the first time. The error is observed on
Switch A %SPANTREE-2-PVSTIM_FAIL: Blocking designated port Fa0/1: Inconsistent superior PVST BPDU received onVLAN 10
How can this error be resolved?
A. Map VLAN 10 to instance 0 in all MST regions.
B. Remove the 1ST root form MST Region 2
C. Configure PVST+ to allow MST Region 1 to be root for VLAN 10
D. Map VLAN 10 into an appropriate instance on switch A
Answer: C
100% Rebirth Cisco 400-101 Questions & Answers shared by Certleader, Get HERE: https://www.certleader.com/400-101-dumps.html (New 911 Q&As)