Cisco 400-101 Free Practice Questions

Question No: 12

Which two statements about scheduling multiple IP SLA operations are true?

A. You must configure IP SLA operations before you can schedule a group of operations.

B. The ip sla monitor group schedule command must be configured on the device.

C. You must configure the frequency of each IP SLA operation before it can start.

D. The IP SLA operations must be scheduled at a maximum interval of 30 seconds.

E. Every IP SLA operation in a single group must start at the same time.

View Answer

Question No: 13

Which statement about Type-4 LSA in OSPFv2 is true?

A. It is present only in the backbone area

B. It is generated by each ABR and forwarded in non-stub areas.

C. It is forwarded in NSSA areas.

D. It is generated by the ASBR and forwarded throughout the wholeOSPF domain.

View Answer

Question No: 14

R1

interface Loopback0

ip address 172.16.1.1 255.255.255.255

interface FastEthernet0/0

ip address 192.168.12.1 255.255.255.0

router eigrp 100 no auto-summary

redistribute connected metric 10000 1 255 1 1500 router ospf1

redistribute eigrp 100

network 192.168.12.0 0.0.0.255 area 0 R2

interface FastEthernet0/0

ip address 192.168.12.2 255.255.255.0

router ospf1

network 192.168.12.0 0.0.0.255 area 0

Refer to the exhibit. While troubleshooting a connectivity issue between R1 and R2, you determine that R1's

Loopback0 network is missing from R2's route table. What is this likely cause the problem>

A. The router is configured to redistribute only broadcast networks

B. The router can redistribute only point-to-point networks

C. The route is excluding the Loopback0 interface fro redistribute because it si redistributing other OSPF

interface

D. The subnets keywords is missing from the redistribute eigrp command on R1

View Answer

Question No: 15

when is it useful to disable split horizon on an EIGRP interface?

A. Disable it when you want to sent routes that are learned from another routing protocol to peer on the same interface

B. Disable it when you want to provide additional backup paths in your network

C. It is never advisable to disable split horizon on an EIGRP interface

D. Disable it when you need to send updates to peers on the interface on which the updates were received

View Answer

Question No: 16

ipv6 nd raguard policy TST-RAGUARD device-role host

int gig0/1

switchport access vlan 100

ipv6 nd raguard attach-policy TST-RAGUARD

Refer to the exhibit. What is the effect of the given configuration?

A. The port rejects inbound router advertisements and router redirect messages

B. The port allows and inspects inbound NDP messages

C. The port blocks inbound tunneled Ipv6 traffic

D. If the Ipv6 RA Guard feature is enabled on VLAN 100, it takes precedence over port- level policy

E. The Ipv6 RA Guard feature is disabled on VLAN 100

View Answer

Question No: 17

Which option is a core event publisher for EEM?

A. Policy Director

B. Applet

C. Script

D. Timer

View Answer

Question No: 18

When do summary black holes occur in eigrp?

A. when a summary is created for security purposes to draw undesired traffic to a termination point

B. when a summary is advertised that contains components that the advertising router cannot reach

C. when the summary is removed due to the last component disappearing

D. when components of the summary are present at multiple summary points

View Answer

Question No: 19

Refer to the exhibit.

When it attempted to register the EEM script, the device returned this error message. Which action can you take to correct the problem?

A. Configure the end command at the end of the BACKUP EEM policy

B. Configure the event none command so that the event can be triggered manually

C. Configure the event action to run the applet

D. Configure the event manager run command to register the event

View Answer

Question No: 20

which condition must be true to allow an access port to trust QoS markings on an incoming frame?

A. The switch must be configured globally with the vlan dot1q tag native command

B. The switch must be configured globally with the mls qos trust cos command

C. The port must be configured with the mls qos trust dscp command

D. The port must be configured with the mls qos cos command

View Answer

Question No: 21

Which three security controls would you take into consideration when implementing IoT capabilities? (Choose

three)

A. Implementing Intrusion Detection Systems on IoT devices

B. Change passwords every 90 days

C. Privacy Impact Assessment

D. Define lifecycle controls for IoT devices

E. Layered Security Approach

F. Place security above functionality

View Answer