Cisco 400-201 Free Practice Questions

Q1. In a frame, the MPLS label is imposed where? 

A. Before the layer 2 header 

B. Within the Layer 3 header 

C. After the Layer3 header and before Layer2 header 

D. After the Layer2 header and before Layer3 header 

View Answer

Q2. Refer to the exhibit. 

Which MPLS TE component keeps track of the flooding and admission control? 

A. MPLS TE priorities 

B. RSVP 

C. link attributes 

D. link manager 

View Answer

Q3. Refer to the exhibit. What is the correct action to fix the L2TPv3 configuration? 

A. At Router-A, correct the local interface in the pseudowire configuration. 

B. At Router-B, correct the encapsulation in the pseudowire configuration. 

C. At Router-A, correct the encapsulation in the pseudowire configuration. 

D. At Router-B, correct the local interface in the pseudowire configuration. 

View Answer

Q4. What is NETCONF? 

A. It is a standard for installing, manipulating and deleting configuration of network devices. 

B. it is a Cisco proprietary solution to help remove the time, cost and manual steps involved in network element configuration. 

C. It is data modeling language, to help remove the time, cost and manual steps involved in network element configuration. 

D. It is a new recommendation which writes device specific CLI scripts while keeping flexibility in a vendor dependence environment. 

View Answer

Q5. What are three actions that the control word performs in MPLS AToM? (Choose three.) 

A. is used to identify the VC label 

B. is used for padding small packets 

C. preserves the sequence of the transported frames 

D. facilitates the load balancing of AToM packets in the MPLS backbone network 

E. carries control bits of the Layer 3 header of the transported protocol 

F. is used to identify the tunnel label 

View Answer

Q6. Refer to the exhibit. The Service Provider does not have IPv6 support in the core, however it does have MPLS support. Customer requires IPv6 connectivity in all sites including Internet access. Without a requirement to create VRF, which method is preferred to support IPv6 traffic between these sites? 

A. 6VPE 

B. H-VPLS 

C. L2TPv3 

D. VPLS 

E. 6CE 

F. 6PE 

View Answer

Q7. Which BGP feature improves the convergence and response time to adjacency changes with BGP neighbors? 

A. reducing BGP scanner timing to the minimum that is supported 

B. BGP Multihop 

C. Next-Hop Address Tracking 

D. Fast Peering Session Deactivation 

E. TTL Security Check 

View Answer

Q8. Refer to the exhibit. OSPFv3 is already running, and R1 has added a new subnet (loopback 11). What is the reason code on R4 when executing the command show ipv6 ospf statistics? 

A. P (partial) 

B. N (network) 

C. R (router) 

D. L (link) 

View Answer

Q9. In which way does the DS-Lite IPv6 transitioning mechanism differ from IPv6 Dual-Stack? 

A. DS-Lite is a combination of tunnel and translation technologies. 

B. DS-Lite is a transition technology that gives full IPv6 connectivity for IPv6 capable hosts that are on the IPv4 Internet but have no native connection to an IPv6 network. 

C. DS-Lite is an automatic tunnel where the tunnel destination is determined by the IPv4 address extracted from the IPv6 address that starts with the prefix 2002::/16. 

D. DS-Lite is a stateless tunneling mechanism with a lightweight and secure manner without requiring upgrades to existing IPv4 access network infrastructure. 

View Answer

Q10. DRAG DROP 

Drag and drop the OAM protocol listed on the left to the correct standard on the right. Not all options will be used. 

View Answer

Q11. The following MPP configuration is applied on RA router: RP/0/RSP0/CPU0:RA#sh running-config control-plane 

control-plane 

management-plane 

inband 

interface TenGigE 0/0/0/0 

allow SSH peer 

address ipv4 5.0.0.0/8 

Which two pieces of information are correct in regards to management traffic on RA router? (Choose two) 

A. SNMP traps going out on TenGigE 0/0/0/0 interface are dropped. 

B. SNMP polling coming through TenGigE 0/0/0/0 interface are dropped. 

C. Telnet connections coming through MgmtEth0/RSP0/CPU0/0 interface are accepted. 

D. SSH connections coming through TenGigE 0/0/0/0 interface from 5.5.5.5 host are accepted. 

E. TACACS traffic going through TenGigE 0/0/0/0 interface are dropped. 

View Answer

Q12. A Server Provider is seeing an increasing amount of attacks against its customers. For which kind of attack would an engineer want to design a Backscatter Traceback solution? 

A. Rogue DNS/DHCP Servers 

B. IP Spoofing 

C. Ping of Death 

D. Distributed Denial of Service 

E. Network Attack TCP/UDP Scan 

View Answer

Q13. Refer to the exhibit. How will the redistributed routes on R1 from EIGRP into OSPF be installed in the R4 routing table? 

A. as a default route with an E2 route type 

B. as a default route with an IA route type 

C. as specific routes with an E2 route type 

D. as specific routes with an N2 route type 

E. as a default route with an N2 route type 

View Answer

Q14. Refer to the exhibit. 

PIM sparse mode is implemented in the network RPF succeeds under which condition? 

A. The RPF check succeeds for the next hop whose router ID is the highest. 

B. The RPF check succeeds for the highest DR priority for the PIM router. 

C. The RPF check succeeds for both PIM neighbors, and traffic load-balances across both neighbors. 

D. The RPF check succeeds for the highest interface IP address for the PIM router. 

View Answer

Q15. Which two flexible service mapping features that are used on the ES40 line card can classify traffic into different service instances, in order to consume fewer VLANs? (Choose two.) 

A. CoS 

B. DSCP 

C. IP precedence 

D. MPLS experimental bit 

E. ToS 

F. EtherType 

View Answer