- Home
- Alcatel-Lucent
- 4A0-100 Exam
Alcatel-Lucent 4A0-100 Free Practice Questions
It is impossible to pass Alcatel-Lucent 4A0-100 exam without any help in the short term. Come to us soon and find the most advanced, correct and guaranteed 4A0-100 Braindumps. You will get a surprising result by our 4A0-100 Exam Dumps.
Check 4A0-100 free dumps before getting the full version:
NEW QUESTION 1
What characteristic of IP addressing creates a hierarchical network?
- A. All hosts on all networks must have unique host number
- B. IP addresses identify a host and the network on which it reside
- C. Clients are assigned 32-bit addresses and servers 64-bit addresse
- D. Router, switch and host addresses are drawn from unique address classe
Answer: B
NEW QUESTION 2
Which of the following command lines would be found in a list of commands designed to permit only certain type of traffic from exiting router RTR-A to router RTR-B?
- A. RTR-A>config>router>if>ingress# filter ip 1
- B. RTR-B>config>router>if>ingress# filter ip 1
- C. RTR-B>config>router>if>egress# filter ip 1
- D. RTR-A>config>router>if>egress# filter ip 1
Answer: D
NEW QUESTION 3
What must the sender do when it receives a window size of 0 from the receiver?
- A. Stop transmittin
- B. Terminate the TCP sessio
- C. Send the next segmen
- D. Retransmit the previous segmen
Answer: A
NEW QUESTION 4
Which of the following statements is TRUE about ICMP?
- A. An IP datagram is encapsulated within an ICMP heade
- B. ICMP messages can only be generated by router
- C. ICMP messages are encapsulated within an IP datagra
- D. ICMP guarantees delivery of a messag
Answer: C
NEW QUESTION 5
Which organization eventually became the standards body for IP and related protocols?
- A. IEEE
- B. IETF
- C. NSFNET
- D. ITU-T
- E. APNIC
Answer: B
NEW QUESTION 6
Which of the following is NOT an example of a Layer 2 protocol?
- A. POS
- B. IP
- C. ATM
- D. Frame Relay
- E. Ethernet
Answer: B
NEW QUESTION 7
What is the function of an LSR?
- A. Label Switching Routers make switching decisions based on the original MAC Heade
- B. Label Switching Routers make routing decisions based on the original IP Heade
- C. Label Switching Routers make forwarding decisions based on the MPLS labe
- D. Label Switching Routers make decisions based on ATM header informatio
Answer: C
NEW QUESTION 8
In the diagram, what type of BGP session is established between the routers of AS 65001 and AS 2002?
- A. IGP
- B. IBGP
- C. EBGP
- D. EGP
- E. BGPcannotbe run between routers in different AS
Answer: C
NEW QUESTION 9
Which of the following statements are TRUE about the Alcatel-Lucent SR 7750? (Choose 2)
- A. It can boot without a compact flash in the CF3 slo
- B. It cannot boot without a compact flash in the CF3 slo
- C. It can operate without a compact flash in the CF3 slot once it has boote
- D. It cannot operate without a compact flash in the CF3 slot once it has boote
Answer: BC
NEW QUESTION 10
In the diagram, what type of BGP session is established between the routers of AS 2002?
- A. IGP
- B. IBGP
- C. EBGP
- D. EGP
- E. BGPcannotbe run between routers in the same A
Answer: B
NEW QUESTION 11
Which of the following is typically a characteristic of Layer 2 framing?
- A. Provides a universal addressing scheme to uniquely identify destinations in the networ
- B. The size of the Layer 2 frame cannot exceed 1518 byte
- C. Provides error checking of the frame contents after transmissio
- D. All the abov
Answer: C
NEW QUESTION 12
Based on the network diagram (click on exhibit),
Router 1 installs the network D in its routing table, based on a dynamic routing update from Router 2. Which of the following describes the information that will be installed in the routing table?
- A. 172.16.9.0/24 next-hop 10.10.10.1
- B. 172.16.9.0/24 next-hop 10.10.10.2
- C. 172.16.9.0.24 next-hop 10.10.10.3
- D. Any of the above
Answer: C
NEW QUESTION 13
Which of the following are TRUE statements about the router ID in OSPF? Choose two
- A. A router ID is not required by OSP
- B. The system address is used as the router ID if router-id is not se
- C. The router ID is used to uniquely identify every OSPF route
- D. On the Alcatel-Lucent 7750 SR, the router ID is set to the highest logical IP address if router-id is not explicitly se
Answer: BC
NEW QUESTION 14
Which of the following statements best characterize Link State Routing? (Choose 2)
- A. Routers periodically send a copy of their routing table to their neighbor
- B. Routers flood link information throughout the entire are
- C. Network converges quickly (within several seconds) after a topology chang
- D. Routers do not have precise knowledge of the entire network topolog
Answer: BC
NEW QUESTION 15
What is the purpose of the Data Link Layer in the OSI model?
- A. The Data Link Layer is responsible for encapsulating the packet into a frame for transmission on the transmission medi
- B. The Data Link Layer is responsible for encapsulating the packet into an IP header and routing the packe
- C. The Data Link Layer is responsible for formatting the packet for applications such as JPEG forma
- D. The Data Link Layer is responsible for timing of the signals on the transmission media
Answer: A
NEW QUESTION 16
When a device in an IP network receives an echo request message that is destined for itself, it then:
- A. Estimates the round trip-tim
- B. Generates an echo repl
- C. Calculates the data loss statistic
- D. Verifies the data field of the messag
Answer: B
NEW QUESTION 17
Which of the following statements is TRUE regarding a VPWS service?
- A. VPWS is a point-to-multipoint servic
- B. VPWS requires MAC learning in order to forward frames to the correct destination
- C. A Spanning Tree Protocol must be enabled when deploying a VPW
- D. VPWS treats multicast traffic similar to unicast traffi
Answer: D
NEW QUESTION 18
Based on the network diagram (click the Exhibit Button),
what are the prefix, mask, and next-hop used on CR1 to setup a default static route to R1?
- A. 0.0.0.0/0 next-hop 10.2 3.2
- B. 0.0.0.0/32 next-hop 10.2.3.2
- C. 10.2.3.2/32 next-hop 0.0.0.0/0
- D. 0.0.0.0/0 next-hop 192.168.2.0
Answer: A
NEW QUESTION 19
Which of the following is characteristic of a static route?
- A. Responds in real time to network failure
- B. Can only be used for routing within an autonomous syste
- C. Uses a hop-count metric to determine the best route to a networ
- D. Explicitly defines the next hop based on operator inpu
Answer: D
Recommend!! Get the Full 4A0-100 dumps in VCE and PDF From 2passeasy, Welcome to Download: https://www.2passeasy.com/dumps/4A0-100/ (New 225 Q&As Version)