4A0-100 Premium Bundle

4A0-100 Premium Bundle

Alcatel-Lucent Scalable IP Networks Certification Exam

4.5 
(45735 ratings)
0 QuestionsPractice Tests
0 PDFPrint version
November 23, 2024Last update

Alcatel-Lucent 4A0-100 Free Practice Questions

Proper study guides for 4A0-100 Alcatel-Lucent Scalable IP Networks certified begins with 4A0-100 Dumps Questions preparation products which designed to deliver the 4A0-100 Free Practice Questions by making you pass the 4A0-100 test at your first time. Try the free 4A0-100 Exam Questions right now.

Check 4A0-100 free dumps before getting the full version:

NEW QUESTION 1
What is the sequence of messages sent by a host when it attempts to ping a destination for which it has no Address Resolution Protocol (ARP) cache entry?

  • A. ICMP echo request, ARP request, ARP reply, ICMP echo repl
  • B. ARP request, ARP reply, ICMP echo request, ICMP echo repl
  • C. ICMP echo request, ICMP echo reply, ARP request, ARP repl
  • D. ICMP echo request, ARP reply, ARP request, ICMP echo repl

Answer: B

NEW QUESTION 2
Which of the following statements describes the purpose of the Transport Layer in the TCP/IP stack?

  • A. Provides a data transport service to higher protocol layer
  • B. Provides a data transport service for routing and control protocols such as OSPF and ICM
  • C. Provides a universal address plan to uniquely identify every device in the networ
  • D. Defines a standard method for framing data for transmission on the physical network mediu

Answer: A

NEW QUESTION 3
In what type of network is a broadcast storm likely to occur?

  • A. An Ethernet network with redundant paths not running ST
  • B. An ATM networ
  • C. A SONET networ
  • D. All of the abov

Answer: A

NEW QUESTION 4
The 201.148.26.0/24 network is subnetted using a /26 mask. How many subnets and host addresses will be obtained with this mask?

  • A. 4 subnets, 64 hosts
  • B. 64 subnets, 4 hosts
  • C. 4 subnets, 62 hosts
  • D. 64 subnets, 2 hosts
  • E. 6 subnets, 30 hosts

Answer: C

NEW QUESTION 5
Which of the following best describes a repeater?

  • A. A passive device simply used to connect two or more cable
  • B. Does not generate or amplify any signal
  • C. A device that receives and retransmits a signal out its ports, but does not do any Layer 2 analysis of the dat
  • D. A device that receives a signal and based on the Layer 2 destination address, makes a decision on which ports the signal should be retransmitte
  • E. A device that receives a signal and based on the Layer 3 destination address, makes a decision on which ports the signal should be retransmitte

Answer: B

NEW QUESTION 6
Which of the following is a characteristic of the IP layer?

  • A. Provides an unreliable, connectionless data transmission servic
  • B. Provides a mechanism for flow contro
  • C. Verifies the integrity of all received datagram
  • D. Provides services equivalent to the OSI data link laye

Answer: A

NEW QUESTION 7
Kahn solved the problem of interconnecting different networks using different protocols by pioneering a new protocol called TCP that was capable of:

  • A. Secure transmission of informatio
  • B. Enforcing a constant packet size to avoid discard
  • C. Allowing remote login
  • D. Providing host to host connectivity with global addressin

Answer: D

NEW QUESTION 8
Which answer reflects the correct message sequence used when a source attempts to ping a destination for which it has no Address Resolution Protocol (ARP) cache entry?

  • A. ICMP echo request, ARP request, ARP reply, ICMP echo reply
  • B. ARP request, ARP reply, ICMP echo request, ICMP echo reply
  • C. ICMP echo request, ICMP echo reply, ARP request, ARP reply
  • D. ICMP echo reques
  • E. ARP reply, ARP request, ICMP echo reply

Answer: B

NEW QUESTION 9
Which of the following protocols belongs to the OSI suite of protocols? (Choose 2)

  • A. OSPF
  • B. BGP
  • C. X.500
  • D. IS-IS
  • E. Ethernet

Answer: CD

NEW QUESTION 10
With a subnet mask of 255.255.255.224, which of the IP addresses below are valid host addresses? (Choose all that apply)

  • A. 17.23.119.63
  • B. 87.99.12.159
  • C. 95.11.22.93
  • D. 192.11.25.87

Answer: CD

NEW QUESTION 11
To transmit its segments of data across the network TCP uses the services of which layer?

  • A. Application Laye
  • B. Transport Laye
  • C. IP Laye
  • D. Data Link Layer

Answer: C

NEW QUESTION 12
Which network was created to replace ARPANET?

  • A. INWG
  • B. ALOHANET
  • C. IETF
  • D. NSFNET

Answer: D

NEW QUESTION 13
Which of the following are correct statements about MPLS labels? (Choose 3)

  • A. A sequence of label actions from one LER to another LER represents a logical tunnel known as an LS
  • B. MPLS labels must be dynamically signale
  • C. Labels are globally significant to the MPLS networ
  • D. MPLS labels may be dynamically signaled or statically assigned by the service provide
  • E. Labels are locally significant to the MPLS route

Answer: ADE

NEW QUESTION 14
Where would you expect to find a P router in a service provider's network? A. At the edge of the provider's network facing the customer.

  • A. At the edge of the customer's network facing the provide
  • B. In the core of the providers networ
  • C. On the customer premise

Answer: C

NEW QUESTION 15
Which of the following is a feature of a VLAN?

  • A. A VLAN allows multiple Ethernet switches to be connected in a single broadcast domai
  • B. A VLAN allows multiple Ethernet switches to be connected in a single collision domai
  • C. A VLAN can separate ports on the same switch into different broadcast domain
  • D. A VLAN can separate ports on the same switch into different collision domain

Answer: C

NEW QUESTION 16
Based on the network diagram (clickthe Exhibit Button).
4A0-100 dumps exhibit
R2 wants to connect a host on 192.168.2.0/24 behind CR1. What is the correct next-hop to use, assuming R1 is configured correctly?

  • A. 10.2.3.2
  • B. 10.1.1.1
  • C. 10.2.3.1
  • D. 10.1.1.2

Answer: B

NEW QUESTION 17
Based on the network diagram (click on exhibit),
4A0-100 dumps exhibit
R2 wants to connect to the networks behind CR1 using a static-route. What is the correct syntax given the choices below? R1 has a valid static-route defined for networks behind CR1.

  • A. config router static-route 192.168.2.0/24 next-hop 10.2.3.2
  • B. config router static-route 192.168.2.0/24 next-hop 10.1.1.1
  • C. config router static-route 192.168.2.0/24 next-hop 10.2.3.1
  • D. config router static-route 192.168.2.0/24 next-hop 10.1.1.2
  • E. none of the above

Answer: B

NEW QUESTION 18
In regards to the Alcatel-Lucent 7750 SR-12 router, how many of the front access card slots are dedicated for Control Processors?

  • A. 1
  • B. 2
  • C. 7
  • D. 10

Answer: B

NEW QUESTION 19
Which of the following is an important advantage of protocol layering? (Choose two)

  • A. Controls distribution of IP addresse
  • B. Simplifies protocol functionalit
  • C. Isolates changes in lower layers from upper layer
  • D. Increases protocol operational efficiencie
  • E. Layering adds to the fragmentation of the data

Answer: CD

Thanks for reading the newest 4A0-100 exam dumps! We recommend you to try the PREMIUM Certleader 4A0-100 dumps in VCE and PDF here: https://www.certleader.com/4A0-100-dumps.html (225 Q&As Dumps)


START 4A0-100 EXAM