Q1. A technician is tasked to build a server requiring the fastest possible performance. Which of the following would achieve this requirement?
A. 10,000 RPM SATA
B. 15,000 RPM SAS
C. SSD
D. USB
Answer: C
Q2. A company has 700 servers installed in 50 server racks in the datacenter. The Chief Technology Officer issued a memorandum to the IT department with a directive to reduce power and cooling consumptions by 50% in the datacenters. Which of the following should thesystemadministrators recommend?
A. Implement 208V 3-phase servers
B. Implement hot aisle / cold aisle
C. Virtualize the servers in the datacenter
D. Replace each server with a blade server
Answer: C
Q3. A technician is assigned a task to configure a new server with six hard drives. The senior administrator requested the technician utilize the drives for maximum fault tolerance. Which of the following RAID configurations should the technician use?
A. RAID 3
B. RAID 5
C. RAID 10
D. RAID 0
Answer: C
Q4. A network administrator is tasked to block all outbound SSH connections on the default port from a network subnet of 10.152.8.0/21 on aLinux based firewall. Which of the following rule sets would accomplish this task?
A. iptables -i OUTPUT -d 10.152.8.0/21 -p TCP --dport 22 -j REJECT
B. iptables -i OUTPUT -d 10.152.8.0/21 -p TCP --dport 23 -j REJECT
C. iptables -i OUTPUT -d 10.152.8.0/21 -p TCP --dport 22 -j ACCEPT
D. iptables -i OUTPUT -d 10.152.8.0/21 -p TCP --dport 23 -j ACCEPT
Answer: A
Q5. A server administrator wants to isolate a SAN hosted LUN to be visible to only a single host. Which of the followingmethodologieswould be used to present the LUN to only that host?
A. LUN masking
B. LUN ID assignment
C. Port mapping
D. Port zoning
Answer: A
Q6. A server administrator has been asked to make recommendations for purchase of a new database server that will be processing all of the company accounts. One area of concern from prior experience is the storage type used by the database server. The server is expected to have a large number of transactions that occur, but will not require a large amount of capacity for the data storage. Given these requirements, which of the following storage criteria are MOST important? (Select TWO).
A. Capacity
B. RPM
C. IOPS
D. Seek time and latency
E. Form factor
F. Bus width
Answer: C,D
Q7. A network administrator is tasked to set up zoning for a SAN infrastructure that requires redundancy. Which of the following types of hardware should the administrator implement?
A. Multiple VLANs
B. Multiple host nodes
C. Multiple HBAs
D. Multiple routers
Answer: C
Q8. A datacenter is in a geologically active area and has no earthquake abatement installed.Which of thefollowingdrive typesisBEST for general server use?
A. Solid state drives
B. High RPM drives
C. Low RPM drives
D. USB drives
Answer: A
Q9. An administrator purchases a new server, which contains only one Xeon processor. This
server is also known as a:
A. load balancing server.
B. multicore server.
C. redundant server.
D. single-core server.
Answer: B
Q10. When looking at an organization's file server configuration, an IT manager determines that several outages are tied to a lack of redundancy in the disk controller configuration. Which
of the following features would the IT manager look for in a new configuration to correct this?
A. Disk shadowing
B. RAID 0
C. Remote journaling
D. Electronic vaulting
E. Disk duplexing
Answer: E
Q11. A technician needs to install six blade servers. Which of the following MUST a technician install along with theblades?
A. Blade rail kits
B. Blade shelves
C. Blade enclosure
D. Blade station
Answer: C
Q12. A company is being audited by its operating system vendor. The company needs to report the number of operating systems in use, the versions of the operating systems, and the product keys. Which of the following will be MOST helpful in passing the audit?
A. Asset management documentation
B. Change management logs
C. Service manuals
D. Server baselines
Answer: A
Q13. Which of the following authentication protocols could be used to authenticate network administrators at a datacenter to manage switches overaremote SSH connection? (SelectTWO).
A. LDAP
B. TACACS
C. RADIUS
D. SNMP
E. IPSec
F. MSCHAP
Answer: B,C
Q14. A technician is tasked with connecting a server to a NAS. Which of the following connection types should be used?
A. HBA
B. Ethernet
C. Fiber Fabric
D. Multiplexer
Answer: B
Q15. Which of the followingdefaultports should be open on a server for remote administration?
A. TCP 25
B. TCP 389
C. TCP 3128
D. TCP 3389
Answer: D