Introducing The New!
Surepassexam Collection
Get Unlimited Access to all
Surepassexam's PREMIUM files
Q1. A technician is tasked with building a test server. Which of the following hard drive types will provide the highest performance?
A. SCSI
B. SAS
C. SATA
D. iSCSI
Answer: B
Q2. Employees working for a company were harmed by toxic fumes during a fire. To prevent this from reoccurring, which of the following cable typesisSAFEST to use?
A. CAT6 cables
B. Plenum cables
C. Fiber cables
D. Coaxial cables
Answer: B
Q3. A technician needs to install six blade servers. Which of the following MUST a technician install along with theblades?
A. Blade rail kits
B. Blade shelves
C. Blade enclosure
D. Blade station
Answer: C
Q4. When troubleshooting a failed backup, atechnician runs the backup using the same tape but on a different tape drive in the same tape library. The backup fails again. Which of the followingshould be the FIRST item the technician should examine as a failure?
A. Tape drive
B. Tape library
C. Tape media
D. Tape capacity
Answer: C
Q5. An administrator is tasked with deploying a server in a telephone switching station. Which of the following voltages will MOST likely be available at the facility?
A. -48VDC
B. 120VDC
C. 220VAC
D. 440VAC
Answer: A
Q6. A technician receives an error messagewhentrying to boot the server stating the operating system was not found. Change management logs indicateanew hard drive backplane was installed in the server last night. Which of the following should the technician do FIRST when troubleshooting the issue?
A. Check system board cables
B. Rebuild RAID array
C. Reinstall server OS
D. Remove newly installed hardware
Answer: A
Q7. An administrator wishes to use KVM remotely to monitor and control a server farm. In order to perform this function:
A. remote control must be disabled on each server.
B. the host must be reachable via the IP address.
C. a serial cable must be available.
D. a monitor must be attached to every server.
Answer: B
Q8. An administrator is updating theserver infrastructure atacompany's disaster recovery site. Currently, an enormous amount of effortisrequired by theadministratorto replicate operations. Which of the followingtypes of siteis the administrator currently using?
A. Cold site
B. Hot site
C. Warm site
D. Replication site
Answer: A
Q9. An email administrator is tasked to setup a Linux mail server.One of the requirements is to close all ports except SSH,HTTPS, SMTP, POP3, and IMAP4.Which of the following commands should be used to see which ports are currently open on the mail server? (Select TWO).
A. lsof
B. netstat
C. ipconfig
D. traceroute
E. ping
F. dig
Answer: A,B
Q10. After a migration to a new server, users report that they are unable to save files to their home directories. A check of the permissions on the home directories indicate that the permissions are set as follows:
User: r-x Group: r-- Other: r-x
A server administrator verifies the correct user and group ownership of the home directories. Which of the following will MOST likely resolve the issue?
A. Add the w permission for the users.
B. Add the x permission for the group.
C. Remove the x permission for other.
D. Remove the r permission for the group.
Answer: A
Q11. Which of the following graphically depicts the movement of information within a system?
A. Site survey diagram
B. Dataflow diagram
C. Architectural diagram
D. Network diagram
Answer: B
Q12. A server technician is performing a server installation. This server must be able to resolve
host names for users running a variety of client operating systems. At a minimum, which of the following services should be enabled on the new server? (Select TWO).
A. NAT
B. DNS
C. LDAP
D. WINS
E. SNMP
F. DHCP
Answer: B,D
Q13. A server has recently been configured as a network firewall. After the firewall was configured, users could no longer access a remote server. Which of the following, if properly configured on the firewall, will allow users to have secure access to the remote server?(Select TWO).
A. Allow TCP port 21
B. Allow TCP port 22
C. Allow TCP port 23
D. Allow TCP port 25
E. Allow TCP port 161
F. Allow TCP port 3389
Answer: B,F
Q14. When using multifactor authentication, which of the following represents “something you have”?
A. A password
B. A PIN
C. A fingerprint
D. An ID card
Answer: D
Q15. A technician is configuring switcheswith SFPports on multiple floors in a building. A switch on the first floor must be connected to a switch on the second floor for trunking VLAN traffic. Which of the following would be the MOST appropriate cable type for the technician to use?
A. Multimode fiber
B. Coaxial cable
C. CAT5e rollover
D. CAT6 straight through
Answer: A